Hornet_2497 answered 6 years ago
That spindle nut can be reused but be sure to replace the used cotter pin with the same good quality one.
I've always reused them, unless they were obviously worn or damaged.
On a 2011 ford ranger with 77000 miles does the front spindle hub nut need replaced when replacing the wheel hub bearing assembly?
2011 Ford Ranger XLT SuperCab 4-Door 4WD
-
Maintenance & Repair
Changing the left front hub on my truck and don't know the torque setting.
2004 Ford Ranger 4 Dr Edge 4WD Extended Cab SB
-
Maintenance & Repair
1999 ford ranger xlt in stuck in low range and when I place the switch in 4 low the 4 low and 4 high lights blink with no engagement to the front hub
1999 Ford Ranger XLT Extended Cab 4WD SB
-
Maintenance & Repair
I have a 1993 Ford ranger 2wd and I found front fenders from a 1999 Ford ranger. Will the 1999 fit the 1993?
1993 Ford Ranger XL Extended Cab SB
-
Maintenance & Repair
FRONT SPRINGS FEEL/SOUND LIKE THEY ARE LOOSE OR RUBBING ON THE CHASSIS SEATS, WHAT COULD BE THE PROBLEM.
2002 Ford Ranger 2 Dr XL Standard Cab SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.