How to bleed air from cooling system on a 2004 Sebring 2.7

Asked by msvin6 Jun 10, 2015 at 09:27 AM about the 2004 Chrysler Sebring LX Convertible FWD

Question type: Maintenance & Repair

Takes about 15 of highway travel an heat gauge climbs rapidly boiles antifreeze into
recovery tank

4 Answers

144,885

To bleed it, crank car remove radiator cap or resivoir cap,fill with fluid till full,then let car heat up,it will burp it self,then replace cap.

6 people found this helpful.
60

Yes. Everyone should try this before taking it to a shop! My '04 sebring with a 2.7 liter engine was overheating, wouldn't hold antifreeze & had no hot air at all. Took radiator cap off, started car & then bled the system of the air that was trapped inside. Runs great now!

2 people found this helpful.
60

Another FYI-if ur 2.7 liter sebring or dodge will not start-check fuses under the hood. It's commonly a 20 amp fuse that is blown. When u find the blown fuse, replace it with a 30 amp fuse. Car should start right up! If no blown fuse, then it more than likely is ur starter

4 people found this helpful.

Your Answer:

Sebring

Looking for a Used Sebring in your area?

CarGurus has 33 nationwide Sebring listings starting at $4,531.

Postal Code:

CarGurus Experts

  • #1
    Sparky222
    Reputation
    4,980
  • #2
    ces13
    Reputation
    2,860
  • #3
    C Daigle
    Reputation
    2,770
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chrysler 300
33 Great Deals out of 548 listings starting at $3,999
Used Jeep Wrangler
134 Great Deals out of 4,983 listings starting at $4,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.