My alarm won't set by using key it stays red with no noise and use too blink after with a beep how can I fix this cause it was working until I put the key in and slipped

Asked by ajaxmccoy Sep 21, 2014 at 06:17 PM about the 2005 Audi A4 Avant 1.8T quattro Special Edition AWD

Question type: Maintenance & Repair

It only stays red now instead of flashing
with a beep it still has no noise it tak s a
couple seconds too start blinking it's a
wagon and it's year is a 03

45,875

Deathjam4 answered 10 years ago

try this.. on the drivers side center pillar *the place your seat belt is attached* look behind your seat belt for a button. Hold it for 3 seconds, you will see the light on your door alarm light up red then go out before you let go. Try your alarm after that and see what happens

3 people found this helpful.

Best Answer Mark helpful

Your Answer:

My alarm won't set by using key it stays red with no noise and use too blink after with a beep how can I fix this cause it was working until I put the key in and slipped 1 Answer

It only stays red now instead of flashing with a beep it still has no noise it tak s a couple seconds too start blinking it's a wagon and it's year is a 03

2005 Audi A4 Avant 1.8T quattro Special Edition AWD

-

Maintenance & Repair
I had an Audi Avant A4 wagon. It kept having a problem with the oil filter and its size. Have you heard of anything that sounds like this problem? 1 Answer

Dear sirs. I had an Audi A4 Avant wagon. It kept having a problem with the engine and an incorrect oil filter. It seems it was to small for the car. It had to be repaired all the time until they disc...

2000 Audi A4 Avant 2.8 quattro AWD

-

Maintenance & Repair
Hi I need help I have an Audi a4 avant 2003 with about 150,000 miles the car revs high while in drive but won't move forward it rolls down the hill backwards while in drive.it does move in Reverse. 3 Answers

No engine or service lights on. I found oil in my spark plug and coils changing the seals and gaskets. I was wondering would this cause my car to do that or is it something else I should be look ...

Audi A4 Avant

-

Maintenance & Repair
How do I go about flushing the system of an Audi A4 1.8? 3 Answers

It's been sitting for aa year to a little over a year and I just put in a new battery. Thought I should flush the system, but don't know how. Can someone help describe how to do this so I don't have...

1999 Audi A4 Avant 1.8T quattro AWD

-

Maintenance & Repair
cam position sensor code came up on my code reader, car turns over but won't start. Is it more than just a sensor? How can I look at my timing belt to check it? 1 Answer

parked my car, next morning it turned over, started and died. Cam position sensor is the only code that comes up on the code reader but the car does not sound right turning over.

2002 Audi A4 Avant 1.8T quattro AWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.