Chrysler 300M won't start

10

Asked by Nick Mar 20, 2018 at 07:00 PM about the 2000 Chrysler 300M FWD

Question type: Maintenance & Repair

200 chrysler 300m popped codes for in and out
trans speed sensors as well as cam position
sensor. Was advised by all data to replace the
crank position sensor and coolant temp sensor at
the same time. All 5 sensors replaced and a new
battery and car turns on but won't start. Any ideas?
It did start initially after the sensors were swapped
but died after driving a block and hasn't started
since.

3 Answers

360

unhook idle air control valve, disconnect negative battery terminal. go inside of car and start position , doing this drains the power from ecm. or you can wait 30minutes. also check for alarm systems

2 people found this helpful.
10

Did that and still unresolved. There is fuel getting to the rail so the pump is working. When it cranks the rpm does move slightly to 100 or 200. It just won't start from there. I went over and double checked all the connectors and vacuum hoses and battery terminals. Everything is connected. I'm at a loss now.

1 people found this helpful.
10

ECM. Fans. Trimming belt. Radiator. Thermostat.

1 people found this helpful.

Your Answer:

300M

Looking for a Used 300M in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    aztec626bf
    Reputation
    710
  • #2
    Chaddyboy
    Reputation
    660
  • #3
    meanoldmoe
    Reputation
    610
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Mustang
60 Great Deals out of 1,365 listings starting at $4,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.