2011 ram 1500 won’t start
Asked by Guru5LYRR Jan 13, 2018 at 05:23 PM about the 2011 RAM 1500 Big Horn Quad Cab 4WD
Question type: Maintenance & Repair
My truck was having intermittent starting issues ( it
would just crank and not start) now it won’t start at
all. It has progressively gotten worse, now it will just
click sometimes and other times it will start but
immediately die? Anyone else have these issues?
14 Answers
briank9051 answered 6 years ago
My first thought is fuel filter may need to be replaced. Any check engine lights?
No, no check engine lights are on.
I finally got back out to mess around with my truck and look into it further. The asd relay is clicking when the key is turned either to acc or run. The butterfly inside the throttle body is also clicking ( opening slightly then closing) if I remove asd relay it all stops.
I have also tried to swap out the relay and get the same outcome
ThinBlueLine013 answered 6 years ago
Any answers to this yet? I’m having same issues with my 2007
What did you find out what was wrong with your truck? I’m having same issues with my 2011 Dodge Ram 1500 truck
Bad pcm.. Check for power and grounds to pcm if all good change pcm.
I unplugged the battery and plugged back in. It started up. But my key fob shit out and I can only use it as a key. Tried replacing the battery but I need a new one. Feeling like it's related
Took my 2011 Dogde ram 1500 into my mechanic checked everything...fuel pump relay ordered a bypass kit no need for a whole new Tipum mod.
Am having this issue with my 2011. Watched a video where the guy talked through the problem. Replacing the whole Tipum for that tiny little relay?! Somebody was doing the doobies that day. Looks like I’m finding a bypass.
Firefightermike306 answered 4 years ago
I bought a 2012 ram 1500 Laramie longhorn a few weeks ago and now it keep Stalin when I try to start it I don’t know what to do
Guru9NDZ4N answered 2 years ago
Take the fuse block apart in front of the battery. The relay for the fuel pump is soldered on the circuit board. That gets a lose connection . resolder it and you will be fine.