bought a 2012 malibu a week ago and tramission has a jerk on downshift and loses speed "it boggs down on 2nd and 3rd...has 21,000 miles on it ,no dipstick to check fluid..starting to think i made a mistake.

bought a 2012 malibu a week ago and tramission has a jerk on downshift and loses speed "it boggs down on 2nd and 3rd...has 21,000 miles on it ,no dipstick to check fluid..starting to think i made a mistake. 1 Answer

I bought a 2002 Malibu LS v6 3.1 liter engine I took it to get it serviced and I had a tune up new battery and it run good for a month thenmy fuel pump went out I put new one on a month ago 2 Answers

and it went good now it will crank but will not start I put a starter on and it will not start but it will crank can you help me with this problem and tell me what it is to do thank you

I have a 2000 Chevy malibu with the 3.1 L V6 and a week ago my power steering stopped working, its like the car is turned off. I knowit is not a burst line because the fluid was full when i checked it 6 Answers

I have a 2000 Chevy malibu with the 3.1 L V6 and a week ago my power steering stopped working, its like the car is turned off. I knowit is not a burst line because the fluid was full when i checked it...

I had a spoiler put on my 2017 Malibu and first it would not stay closed, and now i cant get it open? 1 Answer

I just had a spoiler installed on my car. The first day my trunk would not close and when my husband closed it the next day it doesnt open.

The roof panel and one cross beam on my mother's 2012 Chevy Malibu was replaced 6 monts ago due to a collision with an incompletely opened garage door. The repair looked perfect. Now, two dents have appeared in the roof panel right where the cross beam was replaced. Is it possible that the original repair and welding was botched somehow? 1 Answer

The paint in the dented areas is unmarked. I'm thinking that the normal flexing and bending of a unibody may have caused this if the original repair was not done right, or possibly a broken weld. Its ...