Please help me! Cheek engine light & EPC light is on & my car will not start!!!!
Asked by Pachello1019 Nov 18, 2011 at 08:40 AM about the 2001 Volkswagen Jetta GLS 1.8T
Question type: Maintenance & Repair
Ok bought vw 2 days ago!! It ran great & yesterday I realized check engine light came
on!,,then today I go out to start car & it will NOT START!!! Everything else came on like
radio, lights etc.!! I happened to notice EPC light is also on! Car rAn fine last night,
absolutely no issues!! I hv no owns Manuel either! Please someone help me!!
Jessica
8 Answers
Without knowing what codes the computer has flagged.. I can't help there.. Every state requires auto dealers to warranty their cars for a limited amount of time. Here in Louisiana it is 3 days. If I were you I would find out, if able let the dealer worry about the fix. If you bought it from an individual, unfortunately you may be SOL.
if you have a road side service have the car towed to a dealer to run a computer check on it. Document everything! This may be covered under the lemon law of your state.
Pachello1019 answered 13 years ago
Tha ms guys for taking time to answer my question" well my dad took. Look at my car & it was the starter so we bought the part $150 (not to bad) and he fixed it she is back in business & running amazing111 Jessica
I have a 2003 Jetta 1.8T and the EPC light came on and the car would not start. I also had a check engine light come on last week. I checked the battery voltage and it was 12.3 Volts (Manual says it should be >12.5V). I replaced the battery and both lights went out and the car starts right up.
Ecp.light come on when starting up the car. And check engine light stay on
Epc light will come on when I started up the car and check engine light stay on please help me
Question . Need help 2004 vw golf ran fine a month ago now the epc light is on car turns over wants to start but does not any ideas 2.0
Radicalbrosif answered 5 years ago
Try checking your Crank Position Sensor. Those can cause EPC lights and engine lights. Also on a scanner the RPMs if it’s running would be erratic. If you test it look for a resistance between pin terminal 2 and 3 of 700 to 1000 ohms