Fordtudor37 answered 11 years ago
I would, remember gaskets dry out if they aren't kept moist at least weekly. Double check the correct location and orientation of every connector, mount and bolt attachment BEFORE taking anything apart. Don't forget to change the oil and filter before start up as well.
I have 2004 3 ltr. engine that drown, I have a 2007 3 ltr. flex-fuel engine to replace it, do I need to change the intake and gasket[s]. fwrinn
2004 Ford Ranger 4 Dr XL Extended Cab SB
-
Maintenance & Repair
is it possible to modify a 2006 ford ranger transmission 4.0 ltr. 4 wheel dr. to work on a 2006 2.3 ltr. 2 wheel drive
2006 Ford Ranger
-
Maintenance & Repair
replaced plugs coil pack intake gasket has good compression and good fuel pressure I heard it could be cam sensor or distributor sensor any ideas?
1996 Ford Ranger XL Extended Cab Stepside SB
-
Maintenance & Repair
While facing under the hood a loud squeeking from the right side by the pulleys What would cause this? Idler pulley Tensioner and belt have been changed
2004 Ford Ranger 4 Dr XLT FX4 4WD Extended Cab SB
-
Maintenance & Repair
I changed out the engines. everything ready to go.. but it will not fire up. I was told that the computer box is not compatible. s their any way I can make it work.
1998 Ford Ranger XL Standard Cab Stepside SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.