I have a 1986 Toyota Pickup 22R Engine 4 speed manual. The water flow has sand in it. I just replaced the head gasket yesterday Sept 15, 2013. Is there anyone who could help me out by telling me what is the best way to get the sand out of the water flow? Thank you.

Asked by 89andrew Sep 16, 2013 at 03:14 AM about the 1986 Toyota Pickup 2 Dr STD Standard Cab SB

Question type: Maintenance & Repair

The Toyota has been sitting for awhile not running. But now the head gasket was replaced. It started up & Idled fine till the one of the freezer plug blew off. So I turned off the truck. When I looked at where the freezer plug blew. I noticed there was sand in the water flow. So there anyone who could help me out, by telling what I need to do from this point? Thank You.

3,400

wlogan answered 11 years ago

i would hope the sand is left from when the block was cast originally and disturbing it now may leed to more problems. replace the freeze plugs that you can. also replace the thermostat if you didn't already and try again.

1 people found this helpful.

Mark helpful

Your Answer:

I have a 1986 Toyota Pickup 22R Engine 4 speed manual. The water flow has sand in it. I just replaced the head gasket yesterday Sept 15, 2013. Is there anyone who could help me out by telling me what is the best way to get the sand out of the water flow? Thank you. 1 Answer

The Toyota has been sitting for awhile not running. But now the head gasket was replaced. It started up & Idled fine till the one of the freezer plug blew off. So I turned off the truck. When I looked...

1986 Toyota Pickup 2 Dr STD Standard Cab SB

-

Maintenance & Repair
1988 toyota pickup 22r and the oil is the color of sand. 3 Answers

1988 Toyota pickup 22r carb model and has been sitting almost a year due to coolant loss through the exhaust. Started it up today for about 5 minutes,cut it off and checked the oil and now it is a sa...

1988 Toyota Pickup 2 Dr STD Standard Cab SB

-

Maintenance & Repair
Just bought a used 1994 Toyota 4x4 ext cab pickup, it runs pretty good, but has a miss in the engine, cannot figure out what is causing it , need help, please give me some ideas, 2 Answers

I put spark plugs in it, new rotor, checked vacuum lines, new muffler, and tail pipe. I checked oxygen sensor, I have not checked fuel injectors yet. So what else?

1994 Toyota Pickup 2 Dr SR5 V6 4WD Extended Cab SB

-

Maintenance & Repair
I have an 89' Toyota pickup, its a 5-speed manual with a V6. The other morning when I went to start it, it wouldn't start, after getting my Fiance to come give me a push down the driveay it started right up and didn't do it again the whole day. Today as I was driving down my road it just cut off and wouldn't start back up. What could be the issue? 1 Answer

I have an 89' Toyota pickup, its a 5-speed manual with a V6. The other morning when I went to start it, it wouldn't start, after getting my Fiance to come give me a push down the driveway it started...

1989 Toyota Pickup 2 Dr Deluxe V6 Standard Cab LB

-

Maintenance & Repair
I need 4 9mm 1.25" bolts for the manifold on a 1987 Toyota Pickup. I can't find them anywhere can you help me? 5 Answers

My son is looking to repair his truck and we can't find anywhere that has 9mm bolts that go to the manifold. I know the truck is old but he loves it. The bolts are 1.25 and I need 4 of them. can you h...

1987 Toyota Pickup 2 Dr STD Extended Cab SB

-

Maintenance & Repair

Used Toyota 4Runner

15 Great Deals out of 341 listings starting at $9,900

Used Ford F-150

296 Great Deals out of 15,534 listings starting at $1,712

Used Toyota Land Cruiser

78 listings starting at $27,995

Used Ford Ranger

14 Great Deals out of 1,451 listings starting at $2,888

Used Toyota Corolla

110 Great Deals out of 1,961 listings starting at $1,995

Used Jeep Wrangler

144 Great Deals out of 5,075 listings starting at $6,995

Used Toyota Camry

51 Great Deals out of 944 listings starting at $2,212

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have a 1986 Toyota Pickup 22R Engine 4 speed manual. The water flow has sand in it. I just replaced the head gasket yesterday Sept 15, 2013. Is there anyone who could help me out by telling me what is the best way to get the sand out of the water flow? Thank you.

1 Answer

Your Answer:

Shortcuts

Search Toyota Pickup Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I have a 1986 Toyota Pickup 22R Engine 4 speed manual. The water flow has sand in it. I just replaced the head gasket yesterday Sept 15, 2013. Is there anyone who could help me out by telling me what is the best way to get the sand out of the water flow? Thank you.

1 Answer

Your Answer:

Related Questions