ok mmaybe i better tell you guys this my bronco runs fine whenit is cold outside. it shuts off while driving over about7 miles when the tempature is above 70 degrees out side. if it was the temp sense

Asked by rmiller14 May 04, 2015 at 12:51 PM about the 1986 Ford Bronco II Eddie Bauer 4WD

Question type: Maintenance & Repair

bronco runs fine when its below about70degrees out side. after 70 degrees it shuts off after driving about 7 miles or so. put a new tfi module in the kit from mccully racing and moved it to the fender.new coil and wires. so what is it? if its the temp sensor why dont it shut off in the winter? i can drive it for a couple of hrs and it still goes with out shuting off.if its the pip sensor or the temp sensor why does it run fine in the winter? i took it hunting in the winter and had no problems with it. its only when it is warm out 70 and above when it does this so what is it?

144,795

T_S_T answered 9 years ago

Agree with tennisshoes,check the distributor module,may be bad when it gets hot.

Mark helpful

Your Answer:

ok mmaybe i better tell you guys this my bronco runs fine whenit is cold outside. it shuts off while driving over about7 miles when the tempature is above 70 degrees out side. if it was the temp sense 1 Answer

bronco runs fine when its below about70degrees out side. after 70 degrees it shuts off after driving about 7 miles or so. put a new tfi module in the kit from mccully racing and moved it to the fender...

1986 Ford Bronco II Eddie Bauer 4WD

-

Maintenance & Repair
engine shuts off when above 70 degrees outside. 2 Answers

i am 67 and on social security and do almost all my repairs. i dont have hardly any money left to take the bronco to a garage and pay $60-100 per hour. my bronco shuts off driving when its 70 degrees ...

1986 Ford Bronco II Eddie Bauer 4WD

-

Maintenance & Repair
my 89 ford bronco ii boggs down while taking of it also boggs down when I try to accelerate, what could cause this?? 3 Answers

my truck runs well, it boggs down severely while I accelerate ,especially from a dead stop. if I let off the gas it runs if I give it more gas it boggs . what could be causing this??

1989 Ford Bronco II XLT 4WD

-

Maintenance & Repair
Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this replacement hose. I think my biggest problem is that I do not know what the part is actually called. Does anyone know what this part would be called? Thanks, upfront, for the help. 5 Answers

Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this rep...

1985 Ford Bronco II XLT 4WD

-

Maintenance & Repair
I have a 1985 Bronco II standard shift, I need to change the ECM. where is it located? 1 Answer

I am trying to change out the Engine Control Module (ECM) where will I find it?

1985 Ford Bronco II XLT 4WD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.