1981 Lincoln town car- my distributor rotor has two contacts. which one should I have pointed at #1 when setting up timing?
My 81 town car jumped time when I replaced the distributor. having trouble tuning it in because the rotor has two pins and ive never encountered this before. not sure the rotor postion for #1 plug at tdc.
That is the first model year of the Town Car, geez and it looks mint, don't let it go....but never seen a rotor with 2 contacts either. Especially when the only engine offered was the 5L 302Windsor..pulled up schematics and no help, rotor looks like this for that engine. Maybe get a new rotor, or if you do have #1 at TDC and it doesn't start flip it 180 and see what happens
this is the style I have.
One set of contacts is higher than the other. Ford was trying to keep the contacts as far away from each other as possible to prevent cross-fire. Look on the top of your new cap and find the number 1. Look at the contact that is inside the cap: is it high or low? Set #1 that way. No special tool required - I don't even think one exists. Looks like this old-timer still has it huh?
After trial and error I learned the offset contact is the one to be set for #1 at tdc. not only that but I was setting my timing as you would for a single contact rotor. my firing order was stamped 1 5 4 2 6 3 7 8 on the intake so that's how I set my plugs. wrong. starting at the #1 pos I had to place my plugs in order of 2 1 3 4 8 6 5 7 for the rotor to make the proper contact at the proper time. lesson learned.
Awesome!
Sounds like you fixed your problem. I think i may have a similar issue. Im working on my 1981 Continental MKVI, engine turns over and gets plenty of fuel, but she wont catch for some reason. I think its the timing because i do have spark. Ive set the wires under the regular 15426378 and then with 21348657 and no dice. New cap and coil. She just keeps turning over and over. Any ideas?
If you have a non vacuum advanced distributor (no other wires or vac tube coming out of the side) everything must jive together to achieve a start. If your timing has jumped, no matter what you do it wont start until the timing has been reset. its a bummer, but was a hard learned lesion. the timing chain isn't very hard to replace and my stock upper gear was plastic with a broken tooth. id assume being the same year you may have a similar issue.
I replaced the spark plug wires and I'm afraid I crossed them. now my engine idles rough. I place the firing order of 15426378 but it runs rough...is number one always under the 1 located on the distributor cap?
