Cruise Control 1981 Camaro
I have fitted a New Transducer I purchased from Rick Camaros (there support has been less then helpful)
The problem is that it increases in speed same as the old unit did.
I have checked all the vacuum lines they seem to be going to the correct positions. can't find any leaks.
I can't see that is should matter I have an Edelbrock manifold and a Holley 600 carburetor.
Everything works as it should except that it increases in speed on the flat and down hills to the point I have to disengage the cruse by using the break. Uphill (slight grade not steep) it is not as bad.
My question is, have you got any ideas on what I should be looking for to rectify the problem Please, Note, I marked where the adjuster on the side of the Transducer started from and tried adjusting each way, that made no difference at all.
your help would be greatly appreciated