How can I replace old clogged grease fittings on my 30 Ford
155

Asked by richk55 Dec 01, 2015 at 08:06 PM about the 1930 Ford Model A Coupe

Question type: Maintenance & Repair

While greasing the fitting on my 30 Ford I encountered problems with the rear
brake actuator arms fittings being clogged with years of dirt and hard grease
so I could not get any grease into the fitting.  The fittings are located between
the rear brake drum and the wishbone.  The are the direct flow pressed in
type fitting.  How can I remove and replace these fittings?

3 Answers

F_O_R answered 9 years ago

If you can heat the fittings up you might be able to push out the old. hard grease with new grease.

1 people found this helpful.
Mark helpful
155

richk55 answered 9 years ago

I want to replace the grease fittings with the newer type zirk fittings in addition to lubricating the part. The old type fitting allowed dirt and water to get into the orifice the zirk fitting have a ball and spring check valve.

3 people found this helpful.
Mark helpful

F_O_R answered 9 years ago

To install new zerks you will have to drill and tap a hole. Make sure you don't get metal filings in the fitting.

1 people found this helpful.
Mark helpful

Your Answer:

Related Questions

Model A

Looking for a Used Model A in your area?

CarGurus has 3 nationwide Model A listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Ford Model A Questions

CarGurus Experts

  • #1
    30ford95
    Reputation
    380
  • #2
    KenF
    Reputation
    270
  • #3
    Kitsmith
    Reputation
    190
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.