Power window goes down, but not up.
5

Asked by Keaton Nov 19, 2017 at 06:53 PM about the 1989 Mazda MX-6 GT Turbo Coupe

Question type: Maintenance & Repair

Problem: Power window on driver side gets power for both going up and
down, but only rolls down currently. (The fuses are all in working order, the
power to the switch works as it should. Everything was tested with a test
light.)

Second problem: Power does not go to my passenger side window. I have
tried both using the master window switch as well as the passenger window
switch, no power is going to the window motor at all. (Broken wire?)

Im not sure where to go from here, I have the original window motor for the
driver side which im going to replace and see if that fixes the issue.

1 Answer
5,555

Auto_Adrenaline answered 7 years ago

For the driver's side, the motor or actuator is likely weak. It takes much less effort to roll the glass down than to roll it up, and I believe this could be your problem. Replacing the motor should take care of it. As for the passenger side, it sounds like there is a broken or loose connection to the motor. The way to troubleshoot it would be to pull the door panel off and see if you have any wires hanging or cracked.

1 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • Power window goes down, but not up. 1 Answer

    Problem: Power window on driver side gets power for both going up and down, but only rolls down currently. (The fuses are all in working order, the power to the switch works as it should. Everything...

    1989 Mazda MX-6 GT Turbo Coupe

    -

    Maintenance & Repair

  • strong air flow but NO HEAT in cabin 5 Answers

    Not sure if my problem maybe the blend door. I did the following checks based on my problem regarding no heat in cabin. Air flows quite well but not warm/hot. Checked the hoses from heater core both h...

    1993 Mazda MX-6 2 Dr LS Coupe

    -

    Maintenance & Repair

  • Why is my 1996 Mazda MX6 2.5L shaking when accelerating and feels like it's not getting enough fuel/air when pressing the gas pedal? 6 Answers

    This morning on my way to work, my car felt as if it wasn't getting enough fuel/air when pressing the gas pedal to get enough power. When I would accelerate, the car would feel shaky and felt as if ...

    1996 Mazda MX-6 2 Dr LS Coupe

    -

    Maintenance & Repair

  • Temperature guage not working?? 1 Answer

    How do I test the temp guage?? In the morning after the engine has been cool overnight. I turn the key to accessory and immediately within 2 seconds the needle goes 1/3 the way and stays there. Even a...

    1993 Mazda MX-6 2 Dr LS Coupe

    -

    Maintenance & Repair

  • Car Idles Great, but cuts out when you give it gas 3 Answers

    a friend put battery cables on backwards, since then i have had to replace numerous fuses and sensors. When it first happened you couldn't even turn it over. Now I've gotten to where I can turn it o...

    1988 Mazda MX-6

    -

    Maintenance & Repair

Shortcuts

Search Mazda MX-6 Questions

CarGurus Experts

  • #1
    Richard Jones
    Reputation
    120
  • #2
    Andrzej Michalski
    Reputation
    100
  • #3
    Michael Kane
    Reputation
    80
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Mazda MX-5 Miata
3 Great Deals out of 65 listings starting at $7,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.