back lights not working
Asked by GuruCRSZ6 Mar 03, 2019 at 11:00 PM about the 2005 Ford Crown Victoria Police Interceptor
Question type: Maintenance & Repair
All lights work on the front and interior of the vehicle, but all the back lights all don't work. No hazard, tail lights, break lights, turn signal. They all don't work. Checked the fuses. Can someone help with what this could be?
7 Answers
Have you traced the wiring ? There my be a loose wire or a bad ground stoping the connection reaching the back end.
I have not done that. I don't know where to start when tracing the wires.
So look under the car. An start from where the door is an work back. Basically the fuse panel inside ur car an back to the tail lights.
Had the same problem with my 20003 PI71. Issue was the LCM (light control Module) located under dash. Ford has a recall on the LCM but you have to take to the dealer. The closest ford dealer to me is 1oo miles so I found a band aid auto Zone sells for this and it involves unplugging the 2 sets of wires entering into the back of the LCM, then plugging in the Auto Zone adapter into the LCM and then plugging in the 3 sets of wires into the adaptor. This all made for a really tight fit but it worked. Only down side is now for some reason my horn no longer works.
I have the same problem with my 2003 crown vic no taillights or brake lights headlights work all my fuses are good it this is what I found don’t know if it’s the problem or not
Please someone give me an answer ? Im a single Dad , I drive my kids to and from school , bit anyways my back tail lights doesn't work but the brakes do. I checked the bulbs and they're good . its my headlights work but my back ones dont unless I hot the brakes.
If you have checked all fuses then strike and or turn and off emergency flasher switch rapidly, repeatedly. If that doesn't work its probably your light control module is bad.