Asked by 19bitchymom73 Dec 28, 2015 at 08:48 PM about the 2015 Mazda MAZDA6 i Touring
Question type: Maintenance & Repair
How to change the oil and filter on my Mazda 6
2015 with skid plates
HigherRide answered 9 years ago
If it's like the 2014 model, there is a smaller plastic 'access door' in the skid plate near the wheel. It has a couple of plastic bolts and push pins holding it in. Once you remove it you can access the oil filter and drain plug.
How to change the oil and filter on my Mazda 6 2015 with skid plates
2015 Mazda MAZDA6 i Touring
-
Maintenance & Repair
my car was overheating so i changed the head gasket and replaced the water pump which was bad damaged, however the car mixed water and oil before change of the former and now its mixing oil and cool...
2003 Mazda MAZDA6 4 Dr i Sedan
-
Maintenance & Repair
My 2004 Mazda oil motor and trans oil is good, yet while completely stopped and on drive or reverse, the oil light will flicker. With every flicker the motor would jerk and rumble oddly. The gears ...
2004 Mazda MAZDA6 4 Dr s Sedan
-
Maintenance & Repair
There is oil mixed in with coolant in my radiator. Not sure if a head gasket would cause this or what but still runs finger and no overheating..any ideas
2015 Mazda MAZDA6 i Sport
-
Maintenance & Repair
i have just bought a mazda 6 2003 and the oil filler cap is written click and when i turn it clockwise it says click and it wont even rotate anti clockwise to open. please help
2003 Mazda MAZDA6
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.
