Should the tac go up when engine is cranking but not started? I just barely nuges. I was told this could indicate wheather the crank positioning sensor is working>

Asked by GuruXSWN5 Oct 26, 2018 at 03:58 PM about the 1998 GMC Suburban K1500 4WD

Question type: Maintenance & Repair

Engine will run ok for a while and will then stall, surge and stall. Then will not
start. may not start, not consistant have new fuel pump, fuel filter and fuel relay
which made no change. There is some fuel pressure, squirts out 2 inches
when I open shrader valve.

65,590

firebird338 answered 6 years ago

Fuel pressure regulator

Mark helpful

Your Answer:

Should the tac go up when engine is cranking but not started? I just barely nuges. I was told this could indicate wheather the crank positioning sensor is working> 1 Answer

Engine will run ok for a while and will then stall, surge and stall. Then will not start. may not start, not consistant have new fuel pump, fuel filter and fuel relay which made no change. There is ...

1998 GMC Suburban K1500 4WD

-

Maintenance & Repair
Dashboard lights. I have a 1997 GMC Suburban 1500. My dashboard lights don.t come on unless I turn the headlaights on. I believe that they used to come on whenever the truck was running just as the daylight running ights do. When I asked the repair place to fix the dash lights they told me that they only came on when the headlights were turned on. As I have not driven my truck in a while I would like to know if I am remembering incorrectly of if I need to take my truck in and have the dashboard lights repaired so that they will come on when the engine is running. 2 Answers

Should my dashboard lights be on when the engine is running or just when the headlights are actually turned on.

1997 GMC Suburban C1500

-

Maintenance & Repair
GMC 1990 Diesel 3/4 ton suburban.Dead batteries. Trickle charged for 2 hours. Trickle Charger was hot and charge up to 15. Car started up immediately idled for maybe 45 min. went dead again. I heard a low groan motor still running but no lights and gage not charging. It has been sitting 3 months. Has something leaked "evaporated" Not charging. 1 Answer

Truck won't start. Starter: click,click,click etc.Trickle Charger says 12 amps. After about 2 hours Trickle Charger up to 15 amps and Trickle Charger was HOT. Batteries are fairly new. Truck been si...

1990 GMC Suburban R2500

-

Maintenance & Repair
my 1998 suburban doesnt crank but everything else works and the security light flashes 1 Answer

i just recently bought a 1998 GMC suburban. it used to start up fine then it would take a few cranks for it to start up now it doesnt even engage the starter. i replaced the starter only to find tha...

1998 GMC Suburban C1500

-

Maintenance & Repair
Cranking but doesn't turn over 1 Answer

Started up fine until one day it stalled and doesn't turnover.Battery is really weak from cranking it. I noticed that the fuel pump noise which always comes on when I turn the key to start the car....

1999 GMC Suburban K1500 SLT 4WD

-

Maintenance & Repair

Used Chevrolet Suburban

10 Great Deals out of 583 listings starting at $10,900

Used GMC Yukon

14 Great Deals out of 904 listings starting at $4,555

Used Cadillac Escalade

15 Great Deals out of 427 listings starting at $9,995

Used GMC Sierra 1500

132 Great Deals out of 6,515 listings starting at $3,975

Used Chevrolet Tahoe

11 Great Deals out of 891 listings starting at $12,900

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Should the tac go up when engine is cranking but not started? I just barely nuges. I was told this could indicate wheather the crank positioning sensor is working>

1 Answer

Your Answer:

Shortcuts

Search GMC Suburban Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

Should the tac go up when engine is cranking but not started? I just barely nuges. I was told this could indicate wheather the crank positioning sensor is working>

1 Answer

Your Answer:

Related Questions