after replacing clutch and flywheel the engine will start and stall. sometimes I can get it to rev up but will stall when returned to idle. dohc 2.0 l no codes in system. battery was disconnected for a few days.
beatupchevy answered 7 years ago
something decided to quit at that time , could be pure coincidence ,sounds like the IAC valve , these things should of course be tested before buying new , timing will act like that too , was there a rough ride before the work being done ?
No car ran fine. Clutch was slipping. Its also backfiring through the intake manifold occasionally. Like a timing issue. The crank sensor looked ok when i had the flywheel off. Didnt hit it or disturb it during installation.
after replacing clutch and flywheel the engine will start and stall. sometimes I can get it to rev up but will stall when returned to idle. dohc 2.0 l no codes in system. battery was disconnected for ...
2001 Ford Focus ZX3
-
General
just Put in new battery 2 weeks ago had 2 places run codes said it was battery I buy new battery car runs great for 2 weeks then car dies I jump it starts runs 20 mins then stalls so I go buy alter...
2005 Ford Focus ZX4 S
-
General
I noticed a red light blink constantly in my dashboard after the engine is off and the car is locked . But immediately I unlock the car.. it disappears. please what is the meaning of that light?.. ...
2012 Ford Focus SEL
-
General
I have a 2006 Ford Focus CL, from new, been a good car till the last 12 months, electric front windows switch replaced, steering pump replaced, air cond evaporator not working, now clutch gone at ...
2006 Ford Focus
-
General
I asked about three or more questions and I am asking
2000 Ford Focus SE
-
General
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.