Follow up to 1992 Jimmy 4 wheel
20

Asked by Gary Dec 11, 2015 at 11:42 AM about the 1992 GMC Jimmy 4 Dr SLE 4WD SUV

Question type: Maintenance & Repair

Manual vacuum drive 4 wheel drive...
ok, apparently the vacuum is sucking on car(pun). sO HERE IS WHAT I
DID....
-lifted front of car
-Manually pulled actuator cable
-Had car idling in neutral
-Shifted to 4 wheel
-When I spun one wheel, the other went in reverse...is that proper(i assume
so)
-lights finally go back on, apparently the vaccuum switch on top on transfer
case is bad(but not related to question here)

QUESTION(which will probably solve the problem):
When i spin the wheels, is the front drive shaft(car is in neutral) supposed
to spin with wheels, i also put car in drive(WHEELS CHUCKED) and idles
and again the front wheels spin, should the fact that the car is in drive stop
the front wheels from spinning.
OR
the front drive shaft is free moving like that until the car starts to move nad I
need to get all 4 wheels in the air for a proper test.

1 Answer
61,165

Andrew answered 8 years ago

If the front axle actuator is engaged then turning the front driveshaft will spin one or both wheels. When the trans in park and the front axle engaged and you spin one wheel the other should spin opposite of it. With the trans in neutral when you spin one wheel it should spin the driveshaft. With the back wheels on the ground, front in the air, and in 4x4 the front driveshaft should not spin if you try to by hand. It will be free when in 2wd. If it's free spinning while in 4x4 then your transfer case isn't working properly.

Mark helpful

Your Answer:

Related Questions

  • Follow up to 1992 Jimmy 4 wheel 1 Answer

    Manual vacuum drive 4 wheel drive... ok, apparently the vacuum is sucking on car(pun). sO HERE IS WHAT I DID.... -lifted front of car -Manually pulled actuator cable -Had car idling in neutral -Shift...

    1992 GMC Jimmy 4 Dr SLE 4WD SUV

    -

    Maintenance & Repair

  • 1992 jimmy 4 wheel drive stangeness 14 Answers

    Purchased this old beast, most likely completely stock..There are problems going in and out of 4 wheel...mostly 4hi more than 4 low. Sometimes going between the 4's does not work. When it is on it i...

    1992 GMC Jimmy 4 Dr SLE 4WD SUV

    -

    Maintenance & Repair

  • 19987 GMC JIMMY 4 wheel drive 1 Answer

    I have replaced the vacuum switch (which was bad)...the actuator is fine and there is no vacuum leaks...the control module is good...What's next? I am just enough mechanically inclined to be an idiot...

    1998 GMC Jimmy 4 Dr SLE 4WD SUV

    -

    Maintenance & Repair

  • 1992 gmc Jimmy wont stay running 5 Answers

    My 1992 gmc jimmy with the 4.3 v6 TBI will start on starting fluid and idle but dies after about 30 seconds. We have replaced the fuel pump and filter and fuel pressure regulator. could it be the I...

    1992 GMC Jimmy 4 Dr SLE 4WD SUV

    -

    Maintenance & Repair

  • Front wheel bearings on a 4x4 1995 gmc jimmy 2 Answers

    Can you pack the front wheel bearings on a 1995 gmc jimmy 4 wheel drive

    1995 GMC Jimmy

    -

    Maintenance & Repair

Shortcuts

Search GMC Jimmy Questions

CarGurus Experts

  • #1
    Andrew Olsen
    Reputation
    710
  • #2
    Gene Arnett
    Reputation
    530
  • #3
    Fishinmatt99
    Reputation
    510
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet Blazer
16 Great Deals out of 847 listings starting at $21,977
Used GMC Yukon
10 Great Deals out of 836 listings starting at $1,225
Used GMC Sierra 1500
148 Great Deals out of 7,070 listings starting at $3,950
Used Chevrolet S-10
2 listings starting at $12,975

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.