Jeep cranks but won't start
Asked by Momofthree13 Sep 07, 2018 at 10:36 PM about the 1998 Jeep Cherokee Sport 4-Door 4WD
Question type: Maintenance & Repair
I have a 1998 Jeep Cherokee Sport and it
won't crank. The starter works but the
engine won't turn over. I have replaced the
Crankshaft Position Sensor, Ignition Coil,
and Distributor. Have checked all fuses. Any
ideas?
11 Answers
brotherben answered 6 years ago
It could possibly be a faulty new part, ECM, or the security system.
brotherben answered 6 years ago
https://www.youtube.com/watch?v=3o-oBhGWttM
Momofthree13 answered 6 years ago
Still no spark. Traced down all grounds, replaced the new Crankshaft Position Sensor. Found the ECM, but haven't replaced it yet.
Take off distributior cap see if it's turning if no sorry but big job replace timing chain or belt or if lucky it just came off LOL
Try to start in neatral , or power on take of pos cable, wait 1 minute tap 3 times re connect, it resets ecm !
Also ideal air control value , notorious for jeep problem
Hi i have a 2001 grand chearicee has fuel and turns over but wont start But when it dose it runs for bit then dies any ideas an what wrong
Easttenndude2000 answered 5 years ago
Try resetting the codes and the safety switch test!!