Turn Signal Activating Cruise

40

Asked by Vesskel May 30, 2014 at 11:48 PM about the 1992 Mazda 626 DX

Question type: Maintenance & Repair

Just finished doing some work on my car, and after putting everything back in I noticed
that when using my turn signal it activates my cruise along with it. On top of that it
messes with my gauges, either causing my rpms to appear to fluctuate or my fuel gauge
to drop. I'd appreciate any information that might help me fix this problem, thanks.

7 Answers

40

I pulled my transmission and replaced my torque converter seal. I've been focusing my search on connections to the transmission, thinking I might have missed something or left something loose, but haven't found anything yet.

1 people found this helpful.
12,585

From your post,there has to be a wire some where that is ether pinched and grounded or shorting out.Double check it,it,s there some where.

3 people found this helpful.
Best Answer Mark helpful
40

I found it. For anyone interested, it was my ground going to a bracket that holds my cables up and away from the transmission. The bracket and ground connection point were covered in grime and loose. So I cleaned them up, tightened it down, and the problem seems to be gone. Thanks, Shade.

2 people found this helpful.

Your Answer:

626

Looking for a Used 626 in your area?

CarGurus has 1 nationwide 626 listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    littlehorn
    Reputation
    600
  • #2
    Gene Arnett
    Reputation
    280
  • #3
    Daniel Reed
    Reputation
    240
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.