96 Ford ranger 4,0 changed all clutch now it won't take a peddle have bled ser Al times

96 Ford ranger 4,0 changed all clutch now it won't take a peddle have bled ser Al times 1 Answer

I have a 96 Ford ranger, 4 cylinder manual and have a problem I can't figure out. I can start the truck every time with no problem it isles great and I can sit there and rev it all day no problem but if I go to drive it I can make it about 1/2 mile and then that's it, ill press the gas petal and it won't do any thing but kill the gas (no gas) but soon as I take my foot off the gas it will idle just fine and rev fine but won't go anywhere unless I let it sit for a few mins and it will start all over. I have replaced the IAC, TPS and today the external fuel filter that was clogged but same thing. Once in a while if I push the clutch in it will stay at a rev for a sec. Please help 5 Answers

96 Ford ranger need help :(

Can u take a 95 ford ranger v6 transmision and put it on a 96 ford ranger 4 cylinder? 1 Answer

I found a cheap transmision will it wrk

I have power and my ford ranger won't start. could it be my fule pump or a fuse? It's a 3.0v6 2001 1 Answer

My 2001 ford ranger won't start, it's a 3.0v6. Could it be my fule pump or a fuse? I parked my truck and was running,two day's later it won't start, I've got power.

08 Ford Ranger won't start . Won't even make noise . Good battery , new starter even took starter back off and had checked . Changed starter because I could tap it with hammer and start not now 2 Answers

08 Ranger 2.3 L won't start . Tapped solenoid and it started . Put new starter on and now nothing . Took starter back off an tested good . Battery is hot . Terminals clean , put on another ground stil...