Acura Integra Questions Any type
94 Integra 1.8 Dohc Non Vtec How Can I Make This Beat My Buddies 68 Chevy C...
i need cheap mods that improve alot of horsepower i like to stay under 3gs
Integra's
Thinking of getting a acura integra wit b16 swap, headers, cold air, short shift, stage 3 clutch, stage 3 flywheel, and exhaust. What do you think it will run on the quarter?
Integra's
Thinking of getting a acura integra wit b16 swap, headers, cold air, short shift, stage 3 clutch, stage 3 flywheel, and exhaust. What do you think it will run on the quarter?
Integra's
Thinking of getting a acura integra wit b16 swap, headers, cold air, short shift, stage 3 clutch, stage 3 flywheel, and exhaust. What do you think it will run on the quarter?
Is There A Speed Limiter On A 2000 Integra Gsr If So How Do U Take It Off
Further details on your question or topic
What Should I Do To My Car?
i have about 800$ saved up for my gsr, right now its just a few bolt ons, i/h/e, plugs and wires. im not sure what my next step should be, any suggestions?
B13a Turboed
how do u stop a jdm b16a thats has a stage 2 turbonetics turbo from running to rich
Overheating Problem
I was hoping to get some advice here. We have a 1990 Acura Integra that has an issue overheating. We had it checked out by a mechanic and we had all the necessary parts replaced. A month later, the ca...
Overheating
On Long Drives,Or Going up Hills,Will Overheat.Is Full Of coolant,Fans Work,Have Heat In Heater,Bottom Rad. Hose Does Not Get Hot As It Should!Already Replaced Therm.
LS VTEC
LS/Vtec .......... i hear it works better with B16A head is this true and y?
Clutch
what clutch system does this car have, cable or hydraulic? After it was replaced, the clutch seemed to be very soft compared to prior pressure I was feeling before it was replaced. Is this normal? Th...
Ok My Rpms They Good But When I Press The Breaks And Let I The Rpm Goes Up?...
and yuh could hear the rpms going up and down frcuently!
Check Engine Light
I have a 1992 acura integera and the code it is throwing is the number one cylinder possition censor I know the censor itself is good what could the problem be?
Grinding Noise???
my car grings while turning right... but it only grinds while i give it gas, if i coast around a turn it doesnt do it. ive put new axles on both sides and a new half-shaft bearing on the car. oh and i...
Selling A Car?
Hi, I recently got into an accident with my Acura Integra, 2001. It has about 150K on it, no other damage, clean, ran perfect before the accident. My radiators cracked and I need to replace, pretty m...
I Need Input..
i own a 94 4-door GSR. i've got my b18c out and all apart. i had it bored and sleeved it's now a 2.0l with dart sleeves. i've got a golden egle ls crank, 84mm cp 8:1 comp pistons, cp rods CTR cams por...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.