Ford Aerostar Questions Any type
I Need A Gear Shifter Cable For 1991 Aerostar.
The gear shifter is in the floor and I would like a used one. I have tried 2 from advance store and they broke. The engine is 3.0
1997 Aerostar
I am thinking about buying a 1997 areostar tomorrow and just wanted some reviews by owners of same before I buy it Is it a good buy for dependability or are they junk . Tihis one has 117000 mlles on...
93 Aerostar: Why Does Overdrive Disengages At 70mph After 2hrs Of Driving?
What would cause the the overdrive to disengage after prolonged driving at 70mph with no load, on flat ground? After it drops out of overdrive it wants to down shift from Drive into the passing gea...
Nudging Stuck Cars
Would it damage my Aerostar if I use the nose of the van to nudge snowbound cars out of the snow?
EDIT-Engine Exchanges
I asked earlier about engine swaps-the manufacture date is 12/92-that would make it a '93 model,correct? Would this fit into a 1996 same Aerostar model? Thanks for the previous replies and in advanc...
Cruise Control
fuse is good but cruise does not work
Spark Plugs
I want to change the spark plugs, where are they located
Water Leaking From Timing Cover
Is it possible for water to leak out from the timing cover?
Spark Plug Location
1. Where are spark plugs located and how to replace them? 2. What causes "engin check" light to come on?
I Think I Have A Rearend Problem. I Have Some Whining With Acceleration. Wh...
I am getting some whining with acceleration, so I think I have a rearend problem. I had a mechanic check it because I a small oil leak in the rearend as well. However I get about 13 miles per gallon, ...
Rapid Steering Wobble
For the last 2 years whenever I apply the brakes on my van at speeds over 40 mph I will get a rapid steering wobble. I've replaced the front bearings, outer tie rod ends and had a front end alignment...
Engine Exchanges
Will a 3.0 '92 engine drop into a '96 body of same style? Any modifications? What would be a fair price to remove 2 engines and replace one?-Thanks in advance for your help!
My Front End "shimmy's" Pretty Bad At Around 60-65 Mph.
I recently noticed that the wheel bearing on the pass. side was not seated and the hub nut was loose causing the rotor to move away from the hub.the only thing holding the wheel on was the cotter pin....
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.