Ford Bantam Questions Any type
No Brakes
no brake flued coming out the right rear brake nipple after bleeding
Tatatata Sound In Engine And Jerking At Certain Speeds
Ford Bantam 1.6ixl 2006 model. Recently overhauled. Running reasonably well before engine overhaul. But now has a serious jerking problem especially at 90kph upwards. secondly, the car has a strange...
How Do I Remove The Sump Off A 2006 1.8i Diesel Ford Bantam
all bolts have bee removed te sump is loose and moves around but its as if something is keeping it from coming down.
I Have A Ford Bantam 2002 I Cant Seem To Get My Braks Fuction Right Every ...
Ive replaced master celinder brake pads brake discs and fleud please help
Hi All! My Ford Bantam 2003 Model 1,6i XLE Rocam Engine Is Overheating Afte...
My ford bantam 2003 model 1,6i XLE rocam engine is overheating after few minutes after I started.Fan tested and is functioning well. When I switch on the aircon the fan works fine & when it goes to re...
What Type Of Lights Do You Use In The Dashboard?
My dashboard has blown a couple of lights and I'm looking to replace them with LED but no one can tell me what type of pin I need to buy. Any help please?
2010 WIPER RELAY,WHERE IS IT?
NEED TO FIND THE RELAY,THE WIPERS STOPPED WORKING
Please Any Help Will Be Much Appreciated
Please any help will be much appreciated I have a 2010 ford bantam base model. I am struggling to start it in the mornings when its cold. the funny part is the heat gauge always goes to half when I ...
I Have Ford Bantam 1.3i 2007, While Driving The Heater Just Comes On Whethe...
I have Ford Bantam 1.3i 2007, while driving the heater just comes on whether the AC is on or not, causing heat in the vehicle. pls. help
Ford Bantam Bakkie Don't Want To Start
My ford bantam bakkie do not want to start at all. No lights going on as well as the lights on the dashboard. Battery working. No sound when turning the key.
I Have Problem I Have Changed Oil Pump But Oil Light Still Flashes And Engi...
bantam rocam engine noise I have replaced oil pump but it has noise when Idling or driving
Ford Bantam Brakes
I wondered if i can change my 2011 bantam disk brakes on my own.will i have to bleed the braking system or can i just remove it and fit the new ones?bcoz if i drive normally i have almost no brake...
2008 GENERATOR
2008 Ford bantam charging rate varies from 11.5 to occasionally 13 volts. Could this be fault in Generator please?
Ford Bantam Thermostat Problems
Hi There. Please assist. I have a ford bantam 1.3 2008 model. Recently, hot air from the engin started coming into the cockpit of the car and through the airvents. i took it to an autoelectrician who ...
Where Do You Fill Gear Box Oil In Rocam Engine
Gearbox is noisy and I think it needs oil top up
How Do I Stop Overheating
ford bantam 1.6 rocam 2004 model
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.