Ford Falcon Questions Maintenance & Repair

10

My 64 Ford Falcon Has A Turn Signal Problem.

All the lights work including the dash indicator. I can turn the indicator switch on and the correct direction will light up front and back but will not flash. Have replaced the flasher, wiring harn...

Tail Lights And Dash Lights Not Working In 2003 Ba Falcon And Fuses Look Ok...

Why Won't My 1964 Ford Falcon Start If The Battery Is Okay?

I just hear a clicking sound when I try to start the car. The battery is okay.

I Have A 62 Falcon 2-door That I'mrepairing For My Sons First Car. The Prev...

I Have An 1999 Xh Ute It Will Not Start There Is Power To All But Steruo An...

I Had To Replace The Ignition Switch In My 1961 Ford Falcon. There Are 4 W...

1961 Ford Falcon replacing the ignition switch- the old one has 4 wires, a thicker yellow, red with gray stripe, black and red with green stripe going into the back of ignition. The new switch has ...

1962 Ford Falcon Just Died For No Reason...

the other day i was driving and i was going about 40 mph when the car just died for no reason... I still had power(electrical) but nothing else. The engine wouldn't even turn on...nothing. just dead. ...

I Have A 1960 Ford Falcon I'm Trying To Remove The Drivers Door Handle From...

I have removed the door panel for easier access, I have a special door pin remover, but can not find the curved pin behind the door handle. There is a spring behind the handle but no pin. What can I d...

130

1964 Ford Falcon 2spd Trans 170 Cid Replace Fylwheel?

was wondering is the ring gear or flexplate replaceable my car grinds on in certain spots! not sure what I need to look for? wether or not a flywheel or a ring gear that has to be put on my torque con...

30

What Could Be Causing Complete Instrument And Radio Failure?

My speedometer remains at zero, the temperature gauge is consistently at halfway, the fuel gauge typically shows 1/4 tank but at times rises to just under 1/2 (it is not an accurate reading), the digi...

Falcon Floor Pan Help

I have a 1963 falcon convertable and it needs floor pans. I have tried to find premade floor pan components but Im told no one Is making these. If anyone has some helpful soultions for this problem pl...

80

High Altitude Adjustments To Carb

I have the 170 CI engine and am driving this vehicle predominantly at 6,000 to 7,000 feet altitude. The nearby town of Denver is still 5,000 feet. I remember re-jetting some older cars many years ag...

80

Torque Converter Fluid Change

I am changing the transmission fluid & filter and want to change the Torque Converter Fluid too. Are there any tips or reccomendations for this? I am assuming that there is a Fill plug AND a Drain plu...

How Is The Light Switch Removed From The Dash?

15

65 289 Stumbles At Lower Rpm During Accelleration.

I rebuilt the Autolite 2V carburetor, put in new points, condenser, rotor, cap, and vacuum advance (generic for an M2100). Vacuum at idle is 21 in/m. The vacuum is hooked up to the ported inlet on the...

HOW DO I GET THE MANUAL CHOKE KNOB OFF OF A 1960 FORD FALCON?

Brake Lights Not Working On 1963 Ford Falcon

Will A 1965 Falcon 4 Door Windshild Fit A 1965 Hardtop

My Ks Reader Has Stopped Working But Speed Needle Is Still Working What Cou...

Ford Falcon Experts

  • #1
    Troy Witt
    Reputation
    830
  • #2
    MrBlueOval
    Reputation
    610
  • #3
    Gene Arnett
    Reputation
    330
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.