Ford Falcon Questions Maintenance & Repair
63 Falcon Speedometer Problem.
Hello, I have a 63 Falcon. The problem is the speedometer, I replaced the cable and still nothing. When in drive the speedometer is reading 100. When going in reverse the speedometer works from 100 ...
Where Does The Return Spring For The 144 Cu In One Barrel Carb Go
were does carb return spring go on 144 cu in 1963 falcon
Ticking/tapping Sound From Engine On Acceleration
Hi, I just got a 1968 ford falcon with what I believe to have a 302ci and a 4bbl carb. Engine sounds smooth except when you accelerate you can hear a slight ticking from the passenger side. I think ...
Seating Fabric
can anyone help i am trying to source original seating fabric for a customers car....please could you advise on any suppliers or NOS available to be sent to the UK
Parts
I need help finding a tailgate and glass for a 64 falcon sqire wagon. Any suggestions?
66-69 Falcon Crossmember
Can some tell me for sure that the US 66-69 Falcon front crossmember is the same as the Australian version, in particular engine mounts, and also steering lingage location (apart from the obvious l/r ...
2 Speed Auto Torque Converter Nuts
Are the nuts for the torque converter flanged? If not is there supposed to be any washers? Is there any type spacer or plate between the tranny housing and the engine block? The studs have shoulder...
'64 Falcon Wagon With '86 Mustang Engine Fan Belt Is Squealing
adjusted the alternator because it was slipping to tighten belt as it was really loose, now power steering isn't working. Suggestions?
Fuel Guage
I need some advice I have a 96 EF FALCON and the guage has stopped working any advice / approx $ to fix would be great thanks. the guage its self works it just wont move off E or stays on dead empty ...
Back Glass
Will a back glass from a sedan fit a 2 door Futura? Thanks in advance, Matt
Parts
is any1 wrecking a 1988 ford xf ute im chasing a tailgate and a bonnet has to be in good condition for my car cause im on my l's
I Need Help Trying To Find What Motor Mount To Use For
a v8 302 that has been welded to frame. Car org. motor was inline 6 & PO put in a 302. Does anyone know what mounts I will need to fix this car right. Also rear end has been change out too. 68 Rancher...
1962 Falcon Window Crank Handle Removal Help
I recently bought the window crank handle removal tool and am trying to remove the handle to replace the plastic handle knobs. I can't for the life of me figure out how to use the tool to remove th...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.