Ford Falcon Questions Any type
I Had To Replace The Ignition Switch In My 1961 Ford Falcon. There Are 4 W...
1961 Ford Falcon replacing the ignition switch- the old one has 4 wires, a thicker yellow, red with gray stripe, black and red with green stripe going into the back of ignition. The new switch has ...
Where Is The Number That Tells Me What Size Motor I Have?
I have a 64 and was told there is a 289 in it, but i am skeptical and think it to be a 260 like the vin indicates. The only numbers I see is on the intake which are C40E-9425, but again that's on th...
1962 Ford Falcon Just Died For No Reason...
the other day i was driving and i was going about 40 mph when the car just died for no reason... I still had power(electrical) but nothing else. The engine wouldn't even turn on...nothing. just dead. ...
What Year Did The Falcon Have The Fins On The Back
I had a Falcon in the 70s that had fins on the back it wasn't a 70 tho
Steering Column Size In A 64/65 Falcon/ranchero
The steering column in my 64 Ranchero isn't stock, or pretty. I was going to try to buy a new column with a tilt what length should i get a 30? 32? any info would help thanks
What Car Do I Have?
The VIN on my ford station wagon is 0A40F187987
I Have A 1960 Ford Falcon I'm Trying To Remove The Drivers Door Handle From...
I have removed the door panel for easier access, I have a special door pin remover, but can not find the curved pin behind the door handle. There is a spring behind the handle but no pin. What can I d...
1964 Ford Falcon 2spd Trans 170 Cid Replace Fylwheel?
was wondering is the ring gear or flexplate replaceable my car grinds on in certain spots! not sure what I need to look for? wether or not a flywheel or a ring gear that has to be put on my torque con...
Radio For 1969 Falcon Futura
I have a 1969 Falcon Futura and I'm looking to put a new radio in it. The radio that it currently has is not stock, so I've never seen the original radio. Thankfully the dash was not cut to fit the cu...
65 289 Stumbles At Lower Rpm During Accelleration.
I rebuilt the Autolite 2V carburetor, put in new points, condenser, rotor, cap, and vacuum advance (generic for an M2100). Vacuum at idle is 21 in/m. The vacuum is hooked up to the ported inlet on the...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.