GMC Vandura Questions Any type
Rough Running While In Gear
Hi John.. I have read the past with dragonfly at the top here.. I'm experiencing these same problems as him. . But I don't have. Or can find this gm inline fuel pressure tester. .I can however tel...
What Is The Half Circle Sensor With My Thermostat?
i replaceed my thermostat & theres this flat peice of metal that looks like a sensor is connected to it. It goes around half of the thermostat opening & the bolts go through it. What is it & does it...
95GM2500 Rear Axle Bearing Race Problem. Drive New Bearing 1\2 & Stopped Re...
Welded trick chisel. In the right position to be a race. all messed up now .chisel marks . Welding slag. measured bearing and housing . correct , the thing is in the way . ??? Tks.
R&I Right Rear Axel Bearing 1995 GMC 2500 Vandura
outer race stuck in axle housing
I Unplug My Coolant Temp Sensor And My Car Runs Better Than With It Unplugg...
I've replaced the coolant temp sensor, thermostat, fuel filter, vacuum hoses, checked the fuel pump, replaced the map sensor, idle air control valve, o2 sensor, cleaned the tbi and my car still has a ...
Vandura Won't Start After Recharging Battery.
I have a 1995 Vandura. The battery drained. We recharged it but now when we try to put it back in an alarm goes off, won't silence and the van won't start. Any reset switches etc? We reset the fuse th...
Where Is The Best Place To Get Competitive Insurance For My 1988 5700 GMC V...
Estimated mileage around 3000 miles
Gmc Vandura 2500 Hood
i have a 1990 gmc vandura 2500 i haven't touched since 2004. today i want to drive it but it's low on battery i tried opening the hood but its jammed or something can u guys help just by giving me a ...
My Bed Won't Go Down
how can I fix it and where can I get a motor for it
I Live In The Uk,I Have Got A 1990 Chevy G20 Vandura, Problem With My Speed...
i have now looked on the internet and found out its a common fault.Does anyone know what goes wrong with them. MINE ARE THE ELETRONIC TYPE NOT CABLE
Is There Another Sensor On My 1992 GMC 5.7 That Would Make My Temperature G...
In addition is there any way to check the stock gauge to see if it is working?
Any Problems With Rear Axle
has any one had problems with deflection of the rear axle (where the pumpkin is lower than the center line of the tires)
My 1995 2500 Van Pulls Bad Left When I Hit My Brakes
replaced both calipers and rubber lines
Gm Tbi
95 gmc 4.3 replace tranny with a 1972 350 thm. throttle body problems ever since but vehicle had set 6 months previously. cleaned injectors (kit) fppr now only one injector fires .left sidy r...
Front End Shake After Brake Pad Replacement
i just replaced the front brake pads,put on ceramics because i was told they would not wear out the rotors as bad as metallic pads.now when the brakes get hot i get a bad shimmy.anybody have an idea...
Reset Computer For Idle
my TBI does not have an inbored adjustment screw. do you still use the same procedure . paperclip AB UN plug IAC .......
While Going Into Second Gear There's A Pound Clunk Sound And It Feels Like ...
1993 GMC Vandura 2500 conversion an
Transmission Trouble
I have a 1994GMC Vandura 3500 with a 5.7 L V-8, and automatic trans. Just today on the way home, the transmission started jerking very hard shifting between 1st and second gear. Anyone have any idea...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.