Isuzu Questions Maintenance & Repair
Automatic Shift Lever Problem.
I have a hard time moving the shift lever from park into gear. Do I have a bad switch in the lever, or is there a another switch maybe on the brake peddle that's not working.
Why Wont My 4 Cylinder Rodeo Eccelerate?
My 95 rodeo. Is hard to start once it does finally start you have to be VERY easy with the gas pedal and I mean easy. If u press it more than like a quarter inck it will die you have to accelerate ver...
Isuzu Hombre 1996, Won't Start After Stopping
Starts runs fine until turn it off for about 5-10 min. Then starts but runs rough and dies. won't start again and run fine, for about two hours
When I Press My Clutch In It Wont Start, But After I Play With It, It Will ...
i believe its a front will drive, 5speed, but sometimes i have to kinda push it sideways and play and it will start, whats wrong with it? email me at tammyattk@yahoo.com
2003 Rodeo Driver Window Won't Go Up Even W/ Jumper Wire
have juice w/ jumper wire to motor but no response from window motor
Engine Stalls
My Trooper stalls randomly when driving at low rpm on bumpy roads
Isuzu Trooper Fault Codes P0401&p1441
Hello, I have a 99 Isuzu trooper 3.5l v6. I have to say that I love this vehicle, but since I bought it 2 months ago it has two codes showing p0401(egr) and p1441(evap). The dealer replaced the egr ...
Canadian 1998-1999 Rodeos With ABS Issues
Hi, I am an owner of a 1998 Isuzu Rodeo. I am wondering if any of you have had any issues with your ABS? My ABS light has been on intermittently since 2004. I found out recently that there had been a...
My Gas Gauge Does Not Work. What Would The Part To Replace It Cost And Appr...
My gas gauge does not work. What would the replacement part cost and an approximate labot cost?
Fault Codes
i am have a fault code p0101 does any one know what this meens
Won't Go Into Gear!
replaced the clutch this week and now replaced the slave because we had no pressure on clutch. It still won't go into gear so we're really stumped.
3.0l Engine
Has anyone heard of the camshaft drive sprocket bolts coming loose and falling into the timing drive gears.
C-8 Fuse Under Dash Keeps Blowing Out, Stopping Fuel Supply And Stalling Th...
When fuse was rep;aced the first time, the Trooper started and ran for awhile before blowing out again. The second and third times we tried to replace the fuse, it blew right when we inserted it, eve...
Isuzu 2000 Rodeo 3.2 V-6 Won't Accelerate In Drive Past 5 Mph. No Check En...
I have a 2000 Isuzu Rodeo 3.2 V-6. Just recently it started to not accelerate when in D. It idles fine and doesn't feel rough at all. Also, there are no engine lights or warnings at all. However...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.