Jeep Commander Questions Any type
Engine Light On Noise Upon Start Up O My 2006 Jeep Commander XH CRD V6 5sp,...
Engine light on noise upon start up o my 2006 Jeep Commander XH CRD V6 5sp, any ideas?
2010 Commander , Sometimes Will Turn Over But Not Start Completely! Most O...
Starting to cause problem when starting ! Twice in 2weeks. Sounds like it's turning over but does not start. Same symptoms as a flooded carb! Did minor tune up 1 year ago. Idles at 0.5
2009 Jeep Commander Just Over 200K Miles, Went Into Safe Mode, Engine Won't...
I have a 2009 Jeep Commander that's just over 200K miles, and it went into safe mode and had to get towed home. Can my car be saved? Looking for mechanic diagnose and possibly to repair/replace engi...
5.7 Hemi Oil Leak.
Oil leaking onto exhaust manifold above cat , drivers side. Changed the valve gasket twice. Still is dripping but not from valve cover. Oil in pcv. Engine runs fine.
Jeep Commander Only Drive In 4 Low
My 2006 Jeep Commander ran fine this morning, this afternoon, started fine slipped into gear fine then all of a sudden engine rpms shot up and acted as if in neutral. The front drive shaft spins l...
Car Won't Start At Times
I have a 2007 jeep commander and when am home for the day by the next morning it wont start what is going on and what should I do
2008 Commander Driving Down Freeway Felt Like Muffler Fell Off No Muffler H...
driving stalled while driving now just clicks won't start have power and lights
Jeep Will Not Move Or Will Not Accelerate
It will start but will not accelerate or move forward or reverse but also brake pedal is hard. After starting it and shutting it of it worked fine. The transmission is full and not slipping.
Do L Engage 4wD In Park?
2010 commander Hemi
Do You Take Bitcons For The Purchase Of A Vehicle
Can I buy with bitcons?
My Ad Disappeared When I Uploaded The Ownership Verification Photo
My ad was live and when I uploaded the Ownership Verification Photo, it disappeared. Can you help
MY CAR IS IN LIMP MODE
I need to know how to get my 2006 Jeep commandeer out of limp mode. P0700 which is just a generic code saying there is a tcm fault code. And p2706 which is saying dead circuit to multi solenoid switch...
2007 Keep Commander
I've replaced 3 batteries and 2 alternators since 6/2015. Any other reason why
Temp Gaugr
Just noticed: when idling, the temp gauge goes to hot. But once you accelerate it goes back to normal placement. Fan motor is working.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.