Mitsubishi Mighty Max Questions Maintenance & Repair
I Have A 1986 Mighty Max With A 2.0 Motor In It I Just Put The Motor In And...
i think i might have wried it worng or it messed up the brian
Where Can I Buy A Crank Position Sensor?do I Haveto Buy A New Distributor?
little truck cranks and cranks but will not start.timing is correct ,big fat blue spark and its getting fuel.it should run there is no reason for it not to.is there a way to test the crank angle senso...
Automatic Transmission Fluid Type
Does anyone know what type of fluid the automatic transmission takes?
I Have Misfire At Light Throttle, Worse With Hot Engine
Carbureted engine
How Can I Check Water Pump To Make Sure It's Ok
removed and gutted old stat and reinstalled but left radiator hose off stat housing but still connected to top of radiator. duck taped a garden hose into loose hose and turned water on. water flew thr...
Timing Marksfor1993mitsubishi Mighty Max 2.4L
how do i set the timing marks for a 1993 misubishi mighty max trk.2.4L
Torque Value For Transmission Pan Bolts
changing the tranny fluid and i need the torque value for the transmission pan bolts.
Does Anybody Know Where I Can Get The Tubing For Water Pump
My mechanic tried to replaced the water pump with a new one but found that the "tubing" that connects to the water pump has deteriorated so water is leaking. Does anybody know where we can get that pa...
When Removing To Timing Cover Does The Bottom Pully Have To Come Off First ...
i have tooken all the bolt or nuts on the timming cover still can not remove it to get to water pump. I do not understand why they made it where the timming cover is behind the pully where you can n...
Hard Starting On My 1991 Mitsubishi Truck 5 Speed Manual
1) Sometimes when I start my truck and it misses the first time, I smell gas and it won't start for a little while then I would wait for about 5-10 minutes to start again and will usually start. Th...
5 Speed Transmissions
no one can correct my problem. clutch cable has broke at least 5 times and the plate that holds the gear shifter in place has come loose 3 or 4 times. trans has been rebuilt...cltch has been replace. ...
Where Does The Wire Go?
First I started blowing the MFI Buss fuse that is attached to the battery, I had sparks coming out of the housing that holds the throttle cable, figured short/grounding problem. cleaned up all grounds...
Cutting Out Problems
i have a '88 mighty max sport and it starts to cut out between 2 and 3 grand shifting from third to fourth gear. Does anyone have any ideas on what it could be.
94 Backfiring In The Intake
I have a 94 Mighty Max and it just started backfiring into the intake at lower rpm's. it doesnt do this at higher rpm's. It will be a low level backfire in the intake and I will lose power momentaraly...
Is It Hard To Install A Oil Pump On A 2.4 Engine
need to fine a oil pump, and install it myself
Clutch Cable
put new tranny in would nt go in gear running put new clutch cable cant adjust it old one had some tension on is could washers help old one?
Mitz Mighty Max '95,,the Clutch Is Hard To Push And Its Not Letting The Gea...
also do they make a rear part for the cab,mine is open into the bed ? goodcat60@gmail.com
Why My 95 Mighty Max Wont Start Untill I Pump The Gas For Like 3 Min?
after sitting overnight i try to start and nothing, untill i pump the gas pedal several times... i have change the spark plugs, fuel filter, starter, distribuitor cap and rotor, still does it
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.