Squealing noise from my 92 Dodge Dakota. When I sprayed wd40 on the pulleys the noise went away then I sat it for a little while

Asked by Kevbueno69 Jun 29, 2018 at 10:34 PM about the 1992 Dodge Dakota

Question type: Maintenance & Repair

I be replaced the serpentine
belt and the idler pulley. I still
hear the squealing after I hit
about 1500Rpms. Could I spray
like wd40 on the pulleys while
reving it to determine which
pulley is squealing?

F_O_R answered 6 years ago

There is more than one idler? If you get oil on the belt you should replace it.

Mark helpful

F_O_R answered 6 years ago

If you get your hands down there with the engine running you are going to lose something valuable!

Mark helpful

Your Answer:

Squealing noise from my 92 Dodge Dakota. When I sprayed wd40 on the pulleys the noise went away then I sat it for a little while 2 Answers

I be replaced the serpentine belt and the idler pulley. I still hear the squealing after I hit about 1500Rpms. Could I spray like wd40 on the pulleys while reving it to determine which pulley ...

1992 Dodge Dakota

-

Maintenance & Repair
i have a 1991 dodge dakota 5.2l v8 the water pump went out on it and i let it sit for 2 weeks now when i try to start it up i have to pump the gas for a minuet thin it will idle really rough and it smells like gas i have not replaced the water pump yet and it ran fine when i parked it any ides on what could make this happen? 4 Answers

i have a 1991 dodge dakota 5.2l v8 the water pump went out on it and i let it sit for 2 weeks now when i try to start it up i have to pump the gas for a minuet thin it will idle really rough and it...

1991 Dodge Dakota LE LB RWD

-

Maintenance & Repair
My 94 dodge dakota makes a noise like it wont crank in the morning then i turn the key back and try again and it cranks right up. What is the problem? 1 Answer

Do i need a new fuel filter? How hard is it to install?

1994 Dodge Dakota Sport RWD

-

Maintenance & Repair
I have an 05 Dakota Quad Cab SLT with 3.7L (V6) and it has a 4-speed automatic transmission with overdrive. When I start excellerating from a stop, the truck RPM shifts smoothly through first two gears then it quickly shifts through third to fourth gear which causes truck to bog down. I have press on gas pedal little harder and it shifts back into third and picks up speed then shift into fourth around 48 mph. Is there any computer program for transmission that can change the RPM shift point in the transmission. 2 Answers

Been told by local Dodge/Chrysler/Jeep dealer that they can not do it. The truck also has Tow/Haul setup in it. I do alot of towing, 18 foot RV Trailer, and the quick shifting is causing me to push ...

2005 Dodge Dakota

-

Maintenance & Repair
My 92 dodge dakota will not turn over when I turn the key. 9 Answers

All gauges and lights work. It has a new battery. Had the starter tested and it shows good. Changed the ignition switch and key lock cylinder. Changed the neutral safety switch also. Switched the...

1992 Dodge Dakota Club Cab RWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.