They get oxidized inside and the spring gets bound up. Hope it was replaced. Good Luck!
Hornet_2497 answered 6 years ago
Brian is right but also make sure you are torqueing it in the right direction. It's spring loaded one way. The other way is a dead stop.
Had water pump replaced today when they went to put the belt back on the tensioner pulley won't move what can be wrong
1999 Jeep Cherokee
-
Maintenance & Repair
Hoe do I take the tensioner pulley and arm off the assembly. Is that possible or do I just need to replace the assembly
2001 Pontiac Grand Prix
-
Maintenance & Repair
So last weekend, I was driving home and a heard a clunk under the hood. thought maybe I ran over something. Turning the car was almost impossible. within 2 minutes my car over heated and things went...
2004 Jeep Grand Cherokee Limited
-
Maintenance & Repair
The outer belt is not turning it's the accessory belt to ac and alternator the car starts and idles rough how do I know if it's a bad tensioner or just the pulley on the tensioner?
2000 Mazda Millenia 4 Dr S Supercharged Sedan
-
Maintenance & Repair
The suerptine belt tensioner pulley is stuck or frozen and I cannot get it to move. I've used WD-40, Break Away, I've tapped on it with a wooden hammer. What can I do to free it up?
2005 Pontiac Grand Prix GT
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.