I have an oil leak at the back of the engine block where the vacume hose for the intake manifold is connected. does anyone know how this fitting is removed and if there is a replaceable seal?

25

Asked by bittertruth May 22, 2007 at 05:54 PM about the 1997 Mazda MPV

Question type: Maintenance & Repair

lightGear answered 17 years ago

not sure on the Mazdas. I would get a Chilton or Haynes manual. It will have pics and tell you how to do anything you want to do.

2 people found this helpful.

Mark helpful

295

Bluebird51 answered 17 years ago

I've had four MPV's. The fitting that you are refering to has an Oring in it's base. Even thought this maybe leaking now, I would suggest that the cams plugs in the back of the heads be replaced when the fitting is repaired . All of my vans had them replaced at the 100,000 mile mark as well as 200,000. They are very close to the exhaust manifold and get brittle and leak oil onto the exhaust manifold...

29 people found this helpful.

Mark helpful

Your Answer:

I have an oil leak at the back of the engine block where the vacume hose for the intake manifold is connected. does anyone know how this fitting is removed and if there is a replaceable seal? 2 Answers

1997 Mazda MPV

-

Maintenance & Repair
I have a 2004 Mazda MPV minivan. Can anyone hlep with these questions? Power sliding doors have stopped functioning, will not operate using the interior buttons or the remote. 1st they began to beep constantly, but not work, doesn't matter if engine is running or not, car is in park etc. but still will not work. Have to push off button to stop the beep. Is there a Re-Set button? Where is it located if so. -- next question: Gear indicator light on steering column is out,how labor intensive is it to fix this? Thanks for your help. 1 Answer

Bought this van new & have it serviced and maintained regularly. It is a great family vehicle and relatively dependable. When pushing the button to open the power sliding doors there is no sound at a...

2004 Mazda MPV

-

Maintenance & Repair
1993 mazda mpv 3.0 is there a frost plug in the back of the engine between exhaust manifold and transmission ? 2 Answers

engine overheated cause of broken fanbelt . now when i fill the raiditor the water runs out of the back of the engine below exhaust crossover and above the transmission.

1993 Mazda MPV 3 Dr STD Passenger Van

-

Maintenance & Repair
have 2001 mini van -mazda.. my oil light comes on when i brake, but not when i accelerate?does this mean the sensor is bad.oil is fine not losing any?is this bad if sensor is bad? 1 Answer

was told by buys that installed new oil pan , after i took it in to them ( the light kept coming on)that i needed a new engine... well i cant do that right now-so i use lucas w my oil and check it con...

2001 Mazda MPV

-

Maintenance & Repair
I have a Mazda MPV 2002, oil pressure light came on when car is at idle, engine warm. Now the light comes on when car is warm and i am below 3000 rpm. No knocking or running issues. 3 Answers

Should I get an oil change before I go to my mechanic's(35km)?

2002 Mazda MPV

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.