What might be the problem of my Ford Bantam 1.3i xl rocam
Asked by Guru9ZML6S Dec 20, 2020 at 05:58 AM about the Ford Bantam
Question type: Maintenance & Repair
I bought a new battery for my Ford Bantam 1.3i xl rocam.
After replacing the top gasket and putting everything in order
few days then it started having cold start problems.. It's
making that sound like when the battery does not have
power. While driving and it comes to rest it shut downs. When
I put it in neutral it will idle but reving it will causes it to go
off.. What might be wrong with it.
4 Answers
Chean all the battery terminals and cables connecters to the battery. Add an extra earth cable fron the battery to the gearbox. Check the altinator charging rate.
I have a Ford bantam 1,3i rocam I have overhaul the engine bt now it start when cold and Rev up bt when it gets hot it dies and struggle to start when I get it to start and I want to Rev it up it dies what can the problem be plz help
Check the vacuum pipes that go between the branches of the intake manifold. These are for the EVAP system that channels the fuel tank vapours from the fuel tank breathing system to the intake manifold. Check for any intake vacuum leaks , like the brake booster as well. Check also the Throttle position sensor and wiring.
I did check that pipes there are no cuts or anything and I have replace the throttle position sensor bt it still doesn't work and mby it can be in the brake system because I don't have clutch I don't get the clutch bleeding somewhere is air in the system that I can't get out mby you can also help me with that