Engine wont start over

Asked by Sandile May 29, 2016 at 04:13 AM about the Ford Bantam

Question type: General

my car is 2004 model ford bantam 1.3 with rocam engine, the problem does
not start over the engine, I have ckecked petrol pump with all pipes supply, it
seems ok, the battery is new. One of my friend suspected that the engine lost
"the timing" while car had an accident. please help me what would be the
problem, I also dont understand my friend on his suspicious.

3 Answers
42,415

Auto_Centric answered 8 years ago

Open the "glovebox" storage containment, press the tabs located on each side and allow it to fully open. Locate the inertia switch a Breaker type switch which opens the electrical circuit to the fuel pump On detection of impact! press the switch to reset... Now start the Ford / Rocam. Regards

6 people found this helpful.
Mark helpful
16,935

Guru97FK8 answered 7 years ago

If the vehicle was in an accident, the impact switch was possible which is located on the left side under the dash activated and switched the fuel pump off. On the left side under the dash there is a hole to gain access to this button. Press the button down and it will click into place. You should be able to start the vehicle

2 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • Engine wont start over 3 Answers

    my car is 2004 model ford bantam 1.3 with rocam engine, the problem does not start over the engine, I have ckecked petrol pump with all pipes supply, it seems ok, the battery is new. One of my frien...

    Ford Bantam

    -

    General

  • Rocam engine won't start 19 Answers

    I have bantum 1.6 rocam engine, I recently had piston rings changed, a week later while driving bolt holding cap on piston rod 3 ,broke and broke the oil sump and engine block, I had another subas...

    Ford Bantam

    -

    General

  • Can I over ride my immobiliser to start my 98 bantam bakkie 1 Answer

    Lost my immobiliser at shopping center,I only need it to start the car, it activates the ignition, how do I over ride it to start

    1995 Ford Bantam

    -

    General

  • bantam start failure 3 Answers

    Hi i drive a 2005 1.3 bantam rocam . When its starts i can drive it no problem when i switch it of then it doest want to start again . e left it over night and this morning started up no problem. ...

    Ford Bantam

    -

    General

  • my ford bantam 1.3 rocam engine 1 Answer

    struggles to starts ,when it does it idles and then when the engine is warm it switches off and then battles to start again ,i thought it was the fuel pump but its working

    Ford Bantam

    -

    General

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,620
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.