I have a 96 Chevy 1500 pick up with a 4.3 I replaced the fuel pump because I wasn't hearing it run and it wouldn't start unless I hit the tank with a rubber mallet . no luck, any suggestions
The pump relay and fuse are good still
nothing
The pump relay and fuse are good still
nothing
Check the relay if it clicks its good,if u hear the fuel pump then check for pressusre with a pressure gauge on the fuel line near the engine,and also replace the fuel filter ,they sometimes make the fuel pump go bad
loooozer03 answered 9 years ago
I have already replaced the relay and still the pump won't cut on. Also should the pump run if I just ground it and plug it in without installing it?
The pump relay and fuse are good still nothing
Maintenance & Repair
Hello I have a 2001 chevy cavalier and yesterday morning I tried to start my car and turned over the key and it did absolutely nothing. There was no clicking or winding noises only noise I heard was ...
2001 Chevrolet Cavalier Coupe FWD
-
Maintenance & Repair
I am having problems starting the truck. Right now if the vehicle sits for a couple of hours it will not start unless I spray some starter fluid in the TB. THere are no diag codes. Have checked /...
GMC
-
Maintenance & Repair
I can start the truck when I pour gas into it. But only for a second. It with crank fine but won't start. It only gains to 22psi when I turn on the switch. Every thing tells me it should be 52 ...
1995 Chevrolet S-10 LS Extended Cab RWD
-
Maintenance & Repair
It dies sometime and has trouble starting. I have replaced the fuel tank, fuel pump, fuel filters behind pump and on engine. as if no fuel is reaching the carborater but when i check if lines are push...
1977 Ford F-150
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.