If you know exatcly the position the rotor is in when you pull it,you can replace it fairly simple,remove the one bolt at bottom,unhook wire,s,remove cap,mark the rotor position and the bottom of the distributor for position,pull it up and replace,or set the timing marks,on the crank,and number one plug,before you pull it.
1999 Chevrolet Silverado 1500 LS Extended Cab 4WD
-
Maintenance & Repair
I was looking to tune up my 1993 G30 Cargo Van by replacing the distrubtor, plugs and wires, do an oil change, etc etc as I just bought it used. What is the best way to get at the Distributor, Spark ...
1993 Chevrolet Chevy Van G30 RWD
-
Maintenance & Repair
I'm work on my 97 Chevy silverado has a 350 my distributor is loose like its bolted in but it loose and turn switch causing a misfire is there any way to fix it without changing the distributor
1999 Chevrolet Silverado 1500 Extended Cab 4WD
-
Maintenance & Repair
Trying to put vortex heads on a 1994 350 , I know to change manifold and use spacer to mount TBI. is there anything else that needs to be done?
Chevrolet Silverado 1500
-
Maintenance & Repair
I'm an idiot I understand that. I ran out of gas the other day now my truck cranks over brand new starter, new plugs, distributor cap, now I'm curious my truck is an 89 but it has a dual carbureted ...
Chevrolet Silverado 1500
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.