Remove that specific ignition coil with the engine on and idling if your coil is working you will notice change such as a misfire and rough idle. If there is no change at all and is idling the same way regardless of the coil connected or not then your ignition coil is not working. Cheers
Ignition coils are tested by resistance, (Ω) readings. I do not know what all of them should be, but I do believe Auto Zone can check it for you.
2003 Ford Expedition XLT
-
Maintenance & Repair
can i run a different size tire on the back than i have on the front
2000 Ford Expedition Eddie Bauer 4WD
-
Maintenance & Repair
what does it mean if my 2005 ford expedition will only drive in 2nd gear and reverse? If i put it in drive it will REV up to 4 or 5 and not go any where. so im having to drive it in 2nd gear how can i...
2005 Ford Expedition Eddie Bauer
-
Maintenance & Repair
Case in point: got a spare key cut for the 1998 Ford Expedition. Spare opens the locks, fits in ignition, and starts the vehicle--but then it consistently dies in 1 to 2 seconds. The real key contin...
1998 Ford Expedition
-
Maintenance & Repair
Quick question? I have a 2002 ford expedition that i took the motor and transmission out of and replaced it with a motor and transmission out of an 1998 ford expedition i was gone use the 98 comput...
2002 Ford Expedition XLT
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.