can I put a toggle switch in to disengage the fuel pump when the ignition is off?

Asked by williamsray62 Feb 22, 2015 at 10:05 PM about the 1991 Ford Explorer 4 Dr XLT 4WD SUV

Question type: Maintenance & Repair

When the ignition is off, I can still hear the fuel pump humming. The only way I can turn it off is to take the ground off the battery. Can I toggle it somewhere instead?

159,355

Bob answered 9 years ago

Sounds like the fuel pump relay contacts are welded together. Try a new fuel pump relay.

1 people found this helpful.

Mark helpful

Your Answer:

can I put a toggle switch in to disengage the fuel pump when the ignition is off? 1 Answer

When the ignition is off, I can still hear the fuel pump humming. The only way I can turn it off is to take the ground off the battery. Can I toggle it somewhere instead?

1991 Ford Explorer 4 Dr XLT 4WD SUV

-

Maintenance & Repair
I m in desperate need. I'm older woman,dont kno much bout cars,but plz someone can u tell me where I can find the Fuel Pump Shut Off Switch is at? 2 Answers

Can anyone plz tell me where I can find the FUEL PUMP SHUT OFF SWITCH in my 1997 Ford explorer,v8 awd.? I've looked everywhere.i appreciate any help .thank you

1997 Ford Explorer 4 Dr Eddie Bauer SUV

-

Maintenance & Repair
a light in the dash says fuel reset how do i turn it off the pump is NOT OFF? 1 Answer

the fuel pump is on and working fine but a light in the dash says reset fuel?? what does ti want??

1997 Ford Explorer

-

Maintenance & Repair
i am having a problem with my 1996 ford explorer.when i put the transmission into gear and the car starts to move it makes a loud shaking and clanking noise in the left front end.people are telling me its the hub and knuckle but when i took the tire off i pushed the rotor around and it sounds like it is coming from the shaft after the knuckle can you tell me where to look 1 Answer

i have a 1996 ford explorer and i am having a problem in the front end.when i put the transmission into gear and start to drive there is a loud noise coming from the left front end.if i stop it goes a...

1996 Ford Explorer 4 Dr XLT 4WD SUV

-

Maintenance & Repair
I have a 2003 Ford Explorer 4.0. I'm not getting power to my fuel system. I've replaced the pump, filter, and inertia switch. The old inertia switch connector was melted at the switch. No fuel to eng. 6 Answers

No fuel to engine. When truck is in the on position, the fuel pump runs for a second then shuts off. Need help asap. Out of ideas. Don't really know my way around a car.

2003 Ford Explorer XLS V6

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.