04 grand cherokee ltd frony end noise starts at about 40mph has new cv joints new wheel bearings 3000 miles ago no travel in steering wheel no pulling sounds like slight hum. gets louder at 60 to 70 mph

04 grand cherokee ltd frony end noise starts at about 40mph has new cv joints new wheel bearings 3000 miles ago no travel in steering wheel no pulling sounds like slight hum. gets louder at 60 to 70 mph 3 Answers

I have a 1995 Grand Cherokee Limited and I am randomly getting front end noise. This can be a rumble or even a howl in the driver's front wheel with vibration. This happens at random and I just never know when. Ths is a AWD NP249 TC and we have replaced both front and rear drive shafts, both cv axles on the front end.The transmission was recently rebuilt about 4 months ago too. I just have no clue what's causing this and it's hard to pinpoint when it happens randomly then after cutting car of will be ok later. I'm thinking perhaps differential but would like an expert opinion. 2 Answers

1995 Grand Cherokee Limited AWE with np249 mTC

I have a 2003 grand Cherokee limited. Recently my jeep has been making a low humming sound and vibration at high speeds. Its also drifts like if its got a lose or dead spot in the steering wheel at high speeds. 3 Answers

I've already changed a lot of parts due to a similar problem. I changed all four tirod ends,both front wheel beerings,the ball joints in front, the track bar,right&left CV axels,also rebuilt the fro...

I drive a 98 Jeep Grand Cherokee Laredo and a few weeks ago I turned into a gas station and something made a loud ping noise in the front end, since then when I go over bumps it makes a hollow thump sound and when I hit a lot of bumps at once my steering wheel shakes and I have to slow down for it to stop, any ideas as to whats happening/happened? 6 Answers

I drive a 98 Jeep Grand Cherokee Laredo and a few weeks ago I turned into a gas station and something made a loud ping noise in the front end, since then when I go over bumps it makes a hollow thump ...

I took my 2000 Grand Cherokee in for alignment check. They installed a new right front CV axle shaft, new front and rear gas shocks and did alignment. It still pulled and the steering was off- lots of play in steering, resistance when trying to steer, just felt out of sink with the vehicle. Took it back . They replaced the right front upper outer tie rod end, realigned and installed new rear axle seals. It is still pulling and steering is worse. Lots of resistance, vehicle doesn't respond to steering wheel like it used to. Spent a ton of money and vehicle is worse than when I first took it in. Any advice? Thank you! Jonell 1 Answer

Alignment, steering problems after multiple repairs.