1992 toyota paseo ran great until I turned it off then water came gushing out

Asked by jnetwon2 Apr 21, 2017 at 01:56 AM about the 1992 Toyota Paseo 2 Dr STD Coupe

Question type: Maintenance & Repair

I replaced engine coolant temperature sensor and temperature gauge
sending unit.
I started the car this morning.  It sounded and ran great.  I patted myself on
the back for a job well done.  Premature I would say because when I shut
the car off water came gushing out below the thermostat housing, couldn't
see exactly where.

2 Answers

223,895

Well, of course you need to repair the leak. I suspect you didn't purge the cooling system after the repair. If you take off the thermostat housing, may as well replace the thermostat. The cooling system needs to be purged from air whenever it is opened up. Here is how to purge the cooling system... www.youtube.com/watch?v=zUpXgAJ1gjU

115

Found the leak. It turned out to be the temperature gauge sending unit was not in tight enough! I saw the video prior to my posting the above message. I am not sure yet if my problems with the car are over yet or not. Surely by the end of today!

2 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    getzlaff
    Reputation
    150
  • #1
    T_S_T
    Reputation
    150
  • #3
    Elle64
    Reputation
    110
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.