CITYLIFE404 answered 8 years ago
I believe that system works on vacuum. When it has vacuum there is no 4wd. The side that it jurks towards is most likely the side that is enguageing and the other side is portably stick.... there should be 2 vacuum lines going to each hubs try removing the hoses and see if the 4wd engages manually... but leave the switch in 2 wd so it won't leak vacuum
when I put it in 4x4 it jerks hard left and clunks, I don't know much about 4x4. could it it be the actuators?
2006 Ford F-150 XLT Styleside 4WD
-
Maintenance & Repair
2006 F150 4x4 not working, no light. I used to tap the transfer case motor and it would come on, but it finally quit. I just replaced the transfer case motor and it is not working. If I switch it a ...
2006 Ford F-150 XLT SuperCrew Styleside
-
Maintenance & Repair
I have a 2010 f150 4x4 4.6l that shifts fine from 1 to 2 then into drive but when it gets to drive it's like it's in neutral WTF hoping it's a simple fix just dropped a mother load in front differenti...
2010 Ford F-150 XL 4WD
-
Maintenance & Repair
I have a 2006 Ford F150 fx4 and it was driving fine, stopped to get gas, and it would not start again. The mechanic said " the engine had lost all its compression, and I needed a new engine!" I kno...
2006 Ford F-150 FX4 SuperCrew Styleside 4WD
-
Maintenance & Repair
My 2000 f150 5.4 triton truck has a miss and we looked hooked it up to the computer and it said that the #4 cylinder had a misfire. We took the coil pack out but the bolt will not come out no matte...
2000 Ford F-150 Lariat 4WD Extended Cab SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.