Rear end gear change?

30

Asked by dad3353 Aug 28, 2016 at 01:11 PM about the 1991 Chevrolet S-10 EL RWD

Question type: General

I would like My 1991 S 10 pickup to be
able to cruise at a higher speed than 55
mph, if I change the gears in the rear end
will that do the trick? First gear is so low, I
hardly use it, 5 gear is so low I feel I am
wasting gas and over running the RPM's to
high?

9 Answers

86,825

If you can get a "lower"ratio rear end like a 2.90 or whatever is available for your truck....a 4.11 will give you rapid jack rabbit starts , but it will limit your top speed... See this article, really depends on what you want,. http://www.hardworkingtrucks.com/understanding-axle-ratios/

3 people found this helpful.
159,075

First thing, you need to determine what ratio your differential currently has. Secondly, do you want to spend $400 to $600 or more on changing the ratio? Not only will you need a ring and pinion gear set, you will also need to replace various bearings, shims and seals. Also you will need to deal with the speedometer error that changing the gear ratio will cause.

5 people found this helpful.
30

Thank you both for the answers you gave. It gives me lots to think about, and consider. Do you think it would be worth the it in the long run? Thanks again to both of you for your input and knowledge.

3 people found this helpful.
159,075

That S-10 if it is still stock was designed to do some light hauling and run up and down roads and interstates in it's current configuration. I would leave it as it is. Running it at speed at 3,000 or 3,500 rpm will not hurt it and besides the extra $400 to $600 dollars spent on a new rear gear will take a very long time to get back in fuel savings.

3 people found this helpful.
86,825

dad3353- Look, I don't know what you are trying to achieve, but, if it were me, I would get another vehicle.... WHY? SAFETY. The vehicle is over 25 years old. A lot has changed in 25 years. A newer late model say in 2009 or newer would be a lot better choice.

4 people found this helpful.
61,205

The highest ratio I normally see are 3.73. Typical gearing in a s10 are 3.42's. Do you know what rpm your running in 5th gear? There are glove box rpo codes you can use to see what the truck came with stock. The ones your looking for start with "G" and are 3 digits long. Examples are Gu6 or Gt4.

5 people found this helpful.
10

Just put lil taller profile tires on it. Speedo will be off, but use GPS to confirm actual vs indicated. Bonus...nice new tires.

1 people found this helpful.

1995S 10 pick up I would like to convert rear brake drums to this breaks they make a kit for that

Your Answer:

S-10

Looking for a Used S-10 in your area?

CarGurus has 3 nationwide S-10 listings starting at $12,975.

Postal Code:

CarGurus Experts

  • #1
    Andrew Olsen
    Reputation
    9,860
  • #2
    Robert Smith
    Reputation
    3,420
  • #3
    Gene Arnett
    Reputation
    2,830
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Ranger
18 Great Deals out of 1,529 listings starting at $2,888
Used Ford F-150
321 Great Deals out of 14,968 listings starting at $1,712
Used GMC Sierra 1500
148 Great Deals out of 7,258 listings starting at $3,950
Used Chevrolet Blazer
19 Great Deals out of 872 listings starting at $19,499
Used Chevrolet Camaro
16 Great Deals out of 307 listings starting at $10,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.