Just put in new hydralic clutch system in my 98 s10. But still feels sloppy when shifting. how can I tighten up shifter?

Just put in new hydralic clutch system in my 98 s10. But still feels sloppy when shifting. how can I tighten up shifter? 1 Answer

1989 s10 runs but dies when put in gear 2 Answers

I got a 1989 s10 runs but when I put it in gear it dies. It has the 4.3 what could be the problem

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from under the truck.I looked around and couldn't see anything visibly wrong.I started it up again just fine and started rolling in 1st gear, then I tried to shift to 2nd the truck just stopped and wouldn't go into any gear.At this point the truck will start but when I let the clutch out, it dies(in neutral). Had to remove my drive shaft to be towed on towrope because it wouldn't roll smooth in neutral. When the engine is running now I don't feel any vibration through the gearshift anymore like how I used to before it broke down. What could it be? 3 Answers

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...

how to turn off tailtell security system in a 2002 chevy step side s10 1 Answer

how do i turn off or disable my tailtell security system in a chevy 2002 step side s10

98 s10 clutch 2 Answers

I have a new clutch put in with all new parts. With clutch pushed in I can start the truck let out the clutch and go. After that I can't change gears. With truck off goes into gear fairly easy. I ...