If you want to drive and get your customized car registered for the road, yes you need rear tail lights. The state has a requirement on the illumination required. Make sure you run the proper wire to the lights and they have a good ground so they work. I hope that is what your looking for? If not be a little more precise in your question.
1991 Chevrolet S-10 Blazer 2 Dr STD 4WD SUV
-
Car Customization
I have a 1988 Chevy S10. My brake and tail lights won't work when I cut on my headlights. When in the off position, they do. Checked fuses, replaced one bad bulb, bought and replaced headlight switc...
1988 Chevrolet S-10 Blazer
-
Maintenance & Repair
Brake lights won't work? I have all other lights but no brake lights and I have checked fuses and fusable link and a bunch of other things.
1993 Chevrolet S-10 Blazer 4 Dr Tahoe LT 4WD SUV
-
Maintenance & Repair
I put the cadilac escalade tail lights to my chevrolete suburban 2015 but when i brake the car turns on the blinking light
2015 Chevrolet Suburban 1500 LTZ RWD
-
Car Customization
When I try to put the 4 wheel drive the switch will blink. then both lights will stay on and i don't know if its in high or low 4 wheel drive. some times it just blinks and does not engage at all. whY...
1994 Chevrolet S-10 Blazer 4 Dr Tahoe 4WD SUV
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.