Chevrolet S-10 Blazer Questions Any type
Chevrolet S-10 Starting Problems
i have a 1997 chevrolet s-10 4.3, i Change fuel pump, crankshaft sensor, ingnition coil and control module and still dosnt start it will start with starter fluid and then turns off, i need hel asap ...
91 S10 Blazer 4 3l V6 4x4
When I'm building speed or rmps hard I don't hear anything but when I Take my foot off the gas pedal it makes a shering metal on metal noise but goes away when I am building speed and rpms
Turn Signals Not Working Properly.
Rear turn signals work fine except they flash fast, front both sides flash when either side is activated. And it's a 2001 not 94.
How Large Of A Sheet Of Plexiglass?
What are the width and height of the rear glass? Making temp out of plexiglass and don't want to get to big of a sheet.
1994 S-10 Blazer Stalls Out
My 1994 s-10 blazer has been stalling out. It only happens when it's not under a load. I have recently replaced the fuel pump, distributor cap and rotor, MAP sensor, and taken the battery from a si...
My 91 S10 Blazer 4.3 V6 Tbi
91 s10 blazer 4.3 l v6 4x4 when I start it it turns but have to feather gas pedal to keep running smooth if I take my foot off it runs shitty or dies also when I am driving it around my yard if I h...
What Are Your Thoughts?
Truck is running real rough. I can push the gas petal to the floor and it runs all the way up and sounds good. As soon as I put it in drive it dies. Almost like it’s bogged down. Put it back in pa...
Why Isnt My Right Signal Working?
So, with the lights off, I have all my left signals. Both in the front and the rear. However, I had no right lights with the lights off so i replaced my relay. I now have signals for my left and ri...
Why Isn't My Signal Working?
I have this 91 s10 blazer that has turn signal problems. The left side works fine but the right side doesn't. When the right signal is on, the arrow comes on and stays on, however, neither the fron...
94 S10 Blazer Not Running Right
My 94 s10 blazer drove fine last night with no issues what so ever and fine this morning on my way to work. While breaking my check engine light came on and the oil pressure dropped. I threw it in...
Why Is My Engine Misfiring ?
I replaced my engine in 94 S10 Blazer with a long block 4.3 . It has a miss I can't find. I have changed the plugs , wires , cap and rotor , cleaned injectors and ports . Still misses . I have an ...
S10 Blazer Fuel Problem
Alright, I have an 89 s10 blazer. Have a new fuel pump, fuel pump relay, and all fuses are good. But fuel pump isnt kicking on? Thoughts?
I Dont Know What Kind Of Wire Harnesses To Buy
I have a 92 st blazer 4 door I want to replace the engine harnesses but dont know the right one to buy any help please
Any Help To Figure This Problem Out Would Be Greatly Appreciated
Just in 2 weeks I replaced the water pump,heater core,coolant temp sensor! It seems since all these parts got replaced now my blazer temp is only getting to 125 degreas,heats in cab but not real h...
Ecm
Is the ecm the same in 98 to 2004 s10 blazers
1991 Chevy S10 Blazer Starts On 3 To 5 Cylinders
My car has the 4.3 fuel injected. Every time i start it only starts on 3 to 5 cylinders but if i give it a quarter to half throttle for 5 to 10 minutes it catches on all cylinders and is fine. But t...
Ignition Switch
1995 s10 pickup ignition switch interchangeable with a 1998 s10 blazer
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.