I recently replaced the crankshaft position sensor on my 97 ram 1500 5.9 motor, afterwards it will crank but it acts like it's out of time, sputtering/shaking/blowing white smoke at higher RPMs,help??

I recently replaced the crankshaft position sensor on my 97 ram 1500 5.9 motor, afterwards it will crank but it acts like it's out of time, sputtering/shaking/blowing white smoke at higher RPMs,help?? 1 Answer

98 Dodge Ram 1500 5.9L V8 Mag. so i drove it the other morning and then was messing with Therm sensor and something shorted out. Now my check engine, trans temp and overdrive off light are on. It turns over but not starting, replaced the fuel relay and crank position sensor. Still will not start, could it be the PCM/ECU? someone please help.... 6 Answers

IS IT A BAD PCM/ECU?

my 1999 dodge ram 1500 is shaking like it is out of time. check engine light is on, and blinks sometimes when accelerating 8 Answers

just replaced plug wires, cap, and rotor. I cant keep driving it like this, its killing me. going to take it to the shop ASAP

i have a 1998 dodge ram 1500 sport with a 5.9 gas motor. im trying to figure out what trans i have in the truck. the tag under the hood says bd48. when i look that up it shows for a diesel. so im not sure what trans i have. i cant find any tags on the trans at all but on the bell housing does have 064-2 if that helps any 3 Answers

i have a 1998 dodge ram 1500 sport with a 5.9 gas motor. im trying to figure out what trans i have in the truck. reverse went out this morning .the tag under the hood says bd48. when i look that up ...

2001 ram 1500 5.9 acts like the brakes are stuck when I give it gas. 1 Answer

The brakes are not stuck. It will barely move in reverse and will not move forward. I noticed that the pumpkin is leaking right where it meets the drive shaft.