Forester no start
I have a crank but no start situation on my
2006 Subaru Forester non-turbo 2.5 manual
transmission. The motor has been rebuilt
from the bottom up the first time the motor
was put back again it started right back up
immediately but the piston ring was warped
where I try to put it in by hand instead of
using the tool so it's smoked. I took the
motor back out went and got the ring tool
reinstalled it put it right back in there and it
will crank but no start. It has a brand new
ECU the car does not have an immobilizer so
the only thing I had to do was have the VIN
written in which I did. It has brand new
variable timing solenoid on both heads
brand new engine temperature coolant
sensor brand new oil sending sensor brand
new ECU brand new plugs and wires brand
new ignition coil brand new oil pump water
pump all main bearings rod bearings piston
rings Pistons. My scanner and I do have a
nice one that I paid almost $500 for its a
Bosch says no codes everything checks out
fine everything is in the green according to
the scanner there's no problem. However if
you take the battery out and put it back in
sometimes it will pull up a map code. And if
you take the battery out and put it back in
again it will say there is no codes again. I'm
not understanding it's like something is up in
the wiring or something. The coil is brand
new out-of-the-box but yet it is not firing I
tested the ignition wire that goes into the
coil for hot ground and control. I did both
compression and leave down test everything
showed to be just fine. I'm at my Wit's End I
have put so much money into this car and
now it has a no start situation. I tried to start
it last night while I was working on it and it's
appear to be occasionally of sparked that
came from underneath the motor when you
first started to turn it over. I am wondering if
there is not a chassis ground messed up
somewhere or something and it's causing
the ECU to not get the all the power to both
sides of it or something. If anyone has any
ideas for the love of God please please help
me out thank you